Sometimes it happens that taking their favorite umbrella into the hands, its breakdown is found. It seems to be sorry, but in this form it is not present it. Therefore, we will give a number of tips for repairing an umbrella with your own hands.
1
For starters, go to the storage room. Surely you can find there is not one broken umbrella, which disassemble that you are styled for the upcoming repair. You still need: needle with a thread, a thin line, an old antenna from the receiver, a nail 60, a soldering iron with a tin and chlorine zinc, scissors, screwdriver, passage.
2
If the seam burst on the fabric, then pick up the thread, similar to the color, and neatly squeeze. It happens, the fabric breaks down at the ends of the spokes. Take a thin fishing line, wrap the cloth edge with a few turns and tie a nodule. Ends of the fishing line Grind in the hole on the end of the knitting needles and tie. This work must be performed with a non-tensioned fabric.
3
When the tip of the knitting needles is lit, the fabric does not hold, rushes, the needker scratches. In general, inconvenience mass, but there is a way out. Mix at the end of the knitted thin nichrome wire (from any spiral), then stretch the fabric and tied with a fishing line. It turns out an original ball on the end of the knitting needles. Wash the wire with the passage so that there is a tight and the impulse of the wind did not break the fabric. You can still take a piece of needles from the old umbrella and solder on the broken one. Before soldering the place where the solder lay down, treat with a chlorine zinc. Then the fifth fabric as an ordinary needle.
4
Very often broken the needles. There are several ways to repair. First you need to remove the fabric. Take care of the tissue fastening threads to the umbrella frame, just look at and remember and remember how everything was sewn. Broken needles straighten. If it is a round, pick up the suitable diameter tube (from the antenna), 30-40 mm long, and connect the ends of the knitting of the tube inside the tube. If the knob is groove, take a nail 60 with a hat with a hat and connect the knitting needles by putting the nail into the groove. His edges degenerate around the nail. In both cases, the compounds read by tin, after having finished the place of the solder of the chlorine zinc. After all, sew fabric to the place.
5
If the thrust broke and broke the hinge compound, then first remove the fabric as mentioned above. Then from the tin cut the striq 20x10 mm and wake around a spoiled hinge jack. A rewound strip Sleep tin to the needle. Now you need to drill a hole with a thin drill and wear cravings into place. At the end, sew fabric into place.
6
It happens, the holder breaks and the umbrella ceases to close. We solve the problem. Thin carnation and hammer carefully knock the fixing insert from the handle of the umbrella. Then remove the handle from the tube and get the holder itself. You can straighten it and insert back, but it is better to replace to another. We collect in the reverse order, insert the holder to the place, we dress the handle and clog the hammer locking insert.
We hope our tips will help you leaving your umbrella for a long time.
0
3574
