AIKO safes have a powerful protection against unauthorized persons. In them you can store valuable things, money, papers, etc. It is very important to take care of the locking device and follow the rules of use - then you will not have problems with the opening, unless, of course, you forget your password.
1
Before locking the device, carefully read the instructions. Look if the battery is inserted into the battery compartment. For good operation of the safe, four power elements should work with a voltage of 1.5 V. If any of them is faulty, replace it. Turn the key to the right. Then click the “*” button and wait until the message “Code” or “Open” is displayed on the screen.
2
In the instructions to the safe, you can read which code was set in manufacture. Most likely it is “7-7-7-7” or “1-2-3-4”. Enter the specified code. Then click on the “#” button and wait for the “good” message. Turn the device handle up and open the door. To further use the safe, you need to enter a new password for security purposes.
3
Come up with a good password and on the inside of the door enter the symbol “M”. Enter the code invented and enter the “#” symbol. Remember that your code should include at least two or more than eight signs. If you did everything right, you will see the message “good”. If this is not the case, the error error message will be displayed on the screen. Do not be alarmed, you need to enter a new password again.
4
In the case of an error, repeat the operation of the code installation from the very beginning, starting with the introduction of the “M” symbol. Carry the password only when the device door is open. Check the correctness of the entered code several times. To do this, turn the key to the left side to the stop. Thus, you simulate the closure of the device, and the door will remain open.
5
If you enter the code incorrectly three times, the screen will go out and the locking device will be blocked for several minutes. If at this time you will feverishly press the buttons, the situation will aggravate even more and the lock will be delayed for an indefinite time. When you enter the correct code, the electronic lock is unlocked for several minutes. At this time, turn the handle by turning the clockwise.
6
You can also open the safe with the key. Remove the plug from the plastic panel, which is located between the keyboard and the handle, insert the key and turn it counterclockwise to the stop. If the power of the safe will come to an end, when the “*” symbol is pressed, a signal will sound and a LED blink five times. If possible, try not to close the safe with the saturated batteries - replace them.
7
To close the device, just slam its door. After that, insert the key and turn it in the left. Keep the key and password separately from the device and do not provide information about them to other people. In some safes of AIKO, a code mechanical castle is installed. In this case, to open the door, you need to turn the code handle.
8
To enter the first digit, turn it clockwise until the division is set opposite the figure you need. Do the same with other numbers, except for the latter. When you enter the last digit, turn the handle counterclockwise. The code lock is unlocked and you can open the device.
If you can’t remember the code or the safe is blocked, you will have to contact the service center. Experts will help you open the safe without hacking and unnecessary damage. After that, try to handle the device more carefully.
0
1683
