Mowing the grass in our days is quite simple. If you used to manually manually, now the trimmer will solve all the difficulties for you. Especially with electronic lawn mower is easily and exciting. However, there are some nuances, changing the work of this miracle technology. One of the frequent problems is the wear of the fishing line. We will analyze how to cover the line on the trimmer correctly.
How to wind the line on the trimmer - stage 1
Scrolling the drum to the right, unscrew the nozzle. In it, you will notice the remaining of the old fishing line. Using a screwdriver, open the drum. It is necessary to insert it into a snap-down hole and push a little. Either remove the lock and turn the cover along the arrow. Be careful, be sure to hold the cover, under the pressure of the contents inside the spring, the contents can be saturated. Taking the coil, remove the old fishing line.
How to wind the line on the trimmer - stage 2
Take a new fishing line, turn out 5 meters. Fold it in half. The middle of the fishing line, where the loop was formed, it will be necessary to insert into special recesses located in the middle of the coil. In some models, instead of recesses there are holes. They are needed to secure the fishing line. Pay attention to the hand-drawn arrow that tells the desired winding direction. Important moment - if you notice the presence of two branches in the coil, then you need half the length of the fishing line to wind one way, and the remaining half to another. At the end of the process, do not forget to leave about 20 cm fishing line free, so that then hook them into similar recesses of the top of the coil. The winding procedure is completed.
How to wind the line on the trimmer - stage 3
Now you just have to return the drum to the previous position, correctly complied with all the details. Put the puck and springs in the center of their places. Holding a reel on weight, thread the two end of the fishing line into special side openings and stretch them slightly. Install the coil to your place, while watching the spring and the washer to shift and the ends of the fishing line remained in their excavations. When you make sure that everything is fixed, attach the lid and push it. After the drum flashes, the coil is ready for use!
How to wind the line on the trimmer - general recommendations
It is believed that one replacement of the fishing line is enough for one season of the cat. If you have noticed problems with the technique, while recently wrapped the new line, check the correctness of its winding and make sure the line is well fixed, after reading the instruction again. Also keep in mind that from the type of fishing line the winding rules do not change, be it with a square, triangular, rounded or other patterned cross section.
It turns out that it is not so difficult to wind the fishing line on the trimmer. You just need to use prompts, and technically accurately perform the process of replacing the fishing line. Knowing the principle of winding, you can easily handle the installation of any fishing line on any trimmer model. Kosite with pleasure!
0
584
