Stamps are intended to fix events on various materials. They may be needed in the office (assign copies of different documents), at home (individualize your expensive item). Wheel will turn out to be left on rubber, skin, fabric, metal, surchuche or clay. There are a lot of stamps manufacturing technologies that require special tools or raw materials. But there are also enough simple ways that will help any image easily turn into a stamp at home.
1
Before starting robots, prepare the necessary tools. Find a source of ultraviolet (ultraviolet lamp), a photopolymer, which is required for the basis, where the cliches are cast. Take transparent to better pass the rays of ultraviolet. Cut the glass plates with dimensions of 20 by 20 cm. The plates around the perimeter should be saved by the tape and attach magnets for fixing. There will also be two tanks for liquid, timer, protective and transparent film, water for washing, tracing and toothbrush.
2
Now prepare a sketch. It is defined black and white with china lines. On a computer in a graphics editor, we translate it to the negative. This can be done in Photoshop. The result is printed on a tracker, which is sold in any stationery store.
3
The next step will be irradiated with ultraviolet, but first will conduct some cooking. On the sheets of paper we put an ultraviolet lamp, we put the dishes with water. Now we cut the negative with a margin of one centimeter from the edge and primarily to the glass plate with scotch, so-called bars (only edges should be glued). As a result, a bathtub with a photopolymer should be turned out, at the bottom of which our workpiece.
4
Thus, we begin radiation. Fill the tub for seven millimeters from the plates. needle pierces the air bubbles. Then we place the matte side of the substrate to the bottom and top second plate. Its anchoring magnets. Trays UV lamp and turn it to two hundred seconds. After the overturn blank the other side and repeat the procedure of blowing out.
5
The next step will be the removal of the negative and glass. The substrate should not touch. Polymeric brush wipe bit image by first placing it in the water. Our task - to remove the solid portions from the image of the future die. Further result wiping put back into the liquid under ultraviolet light for ten minutes to dry completely. Finally it is worth to wipe the stamp using the eraser pink color. So you will extend the useful life of the product.
And finally, imagine another simple method for manufacturing dies for quite lazy. Prepare a thin sheet of foil on it doing the drawing. Empty toothpaste from the handle gently pushes small recess. In this groove is filled in an epoxy adhesive, and so leave to dry for two days. Scrollsaw beautiful pen with wood and glue pattern thereto glue "Moment" or the other of this category. And once again send out to dry until completely hardened.
0
932
