What to treat walls from mold

The appearance of mold in the apartment is a real disaster that cannot be ignored. This "velvet enemy" slowly, but confidently destroys decorative decoration in the room and, most importantly, the health of residents. Microscopic mold spores suppress the immune system of adults and children, cause allergic reactions, all sorts of internal organs and mucous membranes. That is why react to the unfinished "living creature" in the house should be immediately immediately!

1
The reasons for the appearance of mold in the apartment

Increased humidity and insufficient indoor air circulation, poorly performed outer waterproofing and damage to interpanel seams, incorrectly installed plastic windows and roof defects, ventilation malfunction and uneven heating of residential rooms - these are the main reasons for the formation of mold foci. Even the breeding of moisthed tropical plants can provoke the appearance of a malicious laid! Most often mold "Attacks" the corners of the room, the shelves of the ceiling with walls, slopes, as well as intercutric seams in the bathroom and in the kitchen. Distinctive signs of its livelihoods are considered a specific crushing smell and colorful spots of a dark brown shade in places of fungal "seedlings".

2
Elimination of mold: action algorithm

The fight against mold mushrooms, reigning in a residential premises - of course, an integrated event: Before proceeding to the mechanical removal of foci of mold from the walls, it is necessary to find out and eliminate the root causes of its appearance. In any case, the apartment should normalize the level of humidity and organize high-quality ventilation. Be sure to repair either replace the current cranes, and the pipes covered with condensate, pack in special boxes or cover the heat insulating paint. Remember, solving the problem of excessive humidity is the first step towards the destruction of dangerous health and wallet of bioprovilation. Ignoring this rule, all subsequent measures taken will, unfortunately, ineffective!

3
Mechanical removal of mold

Removal of a mold with affected surfaces are performed in this order:

Initially conduct a thorough inspection of the entire residential premises. Next, finishing materials are removed from the discovered distressed areas. In order to avoid the intensive spread of the molds of the invisible to the eye, the wallpaper and plaster before dismantling are moistened with warm water.
Then, with a spatula and metal brush, the fungus scrape up to the "native" base - concrete or brick. For prevention purposes also purify and nearby "healthy" sites.
After full-fledged drying, purified surfaces are treated with special antiseptic compositions. Such funds have pronounced fungicidal (antifungal) properties and successfully cope with organic plates of different nature. The antiseptic is applied in 2-3 layers (with an interval of 30-40 minutes) with a wide painting brush.
36 hours after applying the last fungicidal layer, you can proceed to finishing work.

Note! Before starting work with the chemical compositions, it is necessary to dare gauze respirator and protective gloves.

4
Copper Molds to eliminate mold

As an alternative to modern antiseptic drugs, an affordable remedy can be used - a solution of copper mood. When preparing a disinfection mixture, the following proportion is maintained - 15 g of copper sulfate powder for 1 l of clean water. To mix the components, it is better to use a plastic container, for example, a pelvis or bucket. Processing of problem areas with a solution of mood is also carried out in protective equipment - mask and gloves.

5
Prevention of formation of mold

To protect your housing from the re-appearance of mold, follow the following recommendations:

with high humidity (over 40%) to maintain normal microclimate, use household air dryers;
twice a day, arrange through through ventilation;
repair the plumbing timely;
from time to time, clean the ventilation grids in the bathroom and the kitchen;
during repair work, use moisture-resistant materials.