Every motorist with senioritym aware that alignments – they are two different, but very important parameter adjustment angles wheels car. But when the procedure to carry out the measurement and setting the alignment, they know not, alas, all motorists.
1
After replacing at least one of components suspension parts. Even the most minor suspension damage in need of repair, which it can affect the angle of toe-road wheels. Independently carry out the recovery procedure camber – convergence possible, but difficult, it takes time and care. In conditions of normal garage these parameters inaccessible . at stations technical Services of special equipment master quickly simulates the desired angle alignment wheels. At the same time will take into account even the subtle backlash that further led to serious repair chassis cars.
2
After changes in ride height. If changing the ride height of the car, for example, by means of set-top boxes or other devices necessarily requires the alignment procedure wheels. In this disorder-convergence is not required for replacement wheels to a larger or smaller diameter, since their replacement does not affect the setting angle. The main thing - to the replacement turned out not strong mechanical impacts to the undercarriage, which affects the inclination angle wheels.
3
After installing the new spring. Over time, ground clearance reduced slightly, even if there was no intervention in the repair of the car suspension. This is due to the springs under a load of sitting. Therefore, experts recommend checking camber and toe angle at least once a year (preferably in spring). If on the machine to install new springs, it requires two procedures razvala- convergence:. Immediately after the replacement of springs and 1 month, because during this time the ride height may be reduced by 2-3 cm is recommended to change the springs before the winter, together with the installation of rubber according to the season.
4
After the installation of additional equipment weighing 30 kg on the rear axle or the front 100 kg. Regardless of the placement of additional equipment on the vehicle area, the measurement procedure and adjusting alignment angles required for all 4 wheels.
Experts advise to adhere to the above cases, the procedure for the alignment wheels cars to minimize the deterioration of rubber and suitable for you car's behavior on the road.
0
1756
