Bumper often becomes the object of small emergencies. A little more than a high curb, the error when parking - and the shiny surface is covered with scuffs and scratches. With such troubles encountered both beginners and confident motorists. Eliminate the superficial and deep defects on the bumper, you'll be able to, without the help of professionals.
1
Before you go directly to the removal of scratches, it is necessary to diagnose the damage. Thoroughly clean bumper car shampoo from contamination. If necessary, use a solvent. On a clean surface, which also remove traces of rubber, will be clearly visible deep scratches. The extent of damage and determine a way to eliminate them.
2
Minor scuff easily derived using a wax pencil. This corrector will successfully cope with small scratches, completely masking them. Thanks to its balanced chemical composition corrector not only will fill the chips, but also prevent the corrosion of metal. Subsequently a coating which creates pencil withstands the action of natural factors (moisture, sun, hail), and the chemical treatment when the vehicle wash. Buy pencils you can practically in any shop of automobile accessories. They are very inexpensive, especially under the condition that one of the corrector will be enough for many years. Remember that the wax can fill only a thin and superficial scratches.
3
Extensive scratches and damages, which reach the ground will require staining. Paint the entire bumper is required. You will need to properly prepare the damaged area and apply the paint directly on a scratch.
4
After a diligent surface cleaning, all existing scratches must be smoothed with emery paper. Use 1700-1300 caliber sandpaper. Thus, you will remove the layer of damaged varnish, and the surface will become smooth, and therefore suitable for further processing.
5
Deep scratch filled with a layer of putty. When the putty dry, re-apply the fine-caliber sandpaper to align the surface. The next step will be the priming of the surface.
6
To paint the bumper you will need paint in the tone of the surface. Apply it with a special toothpick, matches with a softened end or brushes for manicure. At the stage of staining, you will need concentration, attentiveness and accuracy. Try to achieve the result, in which the paint layer is lifted with the entire surface of the bumper. Leave the car for drying about a day.
7
The final stage is varnish. The easiest way to use a varnish can be sprayed into a painted surface.
When painting the bumper, observe the same rules that act and when painting the entire car. Make sure that the surface is degreased and deprived of dust. With due attention to the details, you can easily eliminate damage from the bumper of the car yourself.
0
17669
