How to deepen the well

More often total level water v the well decreases from–per lowering horizon ground water. V such cases return her can only spending complex activities on deepening well. But not costs hurry with the beginning these work. To you costs little wait, to for sure make sure v volume, what ground water not return on the former level. If v flow month of this not happened – can proceed.

Dredging wells are very time-consuming, and, consequently, expensive. People who do them should be qualified and well-known geological characteristics of the terrain. To ongoing work to be meaningful and lead to the desired result, you need a set of certain conditions:

territory of your land does not allow to dig a new well;
well well it consists of 10 rings or more;
in water was never impurities and odors, it has always been clear;
the cause of the dredging is too weak flow of water.

V some cases, for example, at full ceiling ground water, resort to deepening well generally senselessly, so how no positive result procedure not will, a only will entail per yourself unfounded waste forces and of monetary means. V such cases easier dig new well, a old preserve.

works to deepen the well, you'll need to perform complex:

winch;
a pump for pumping water;
stairs;
shovel;
metal bucket;
steel or plastic tube;
mesh stainless steel;
pit ring;
trowel, cement and water glass.

Depending on the state and type of soil, you can deepen the well in several ways. One of them is a deepening open trunk. This method is great for dense soil and is carried out without the use of additional well rings. Its essence lies in the scoring of the metal pipe into the bottom of the well. Use the pipe whose diameter will be 40-50 centimeters, and the length is 1 meter. If you do not have such a size of such sizes - plastic is suitable. In the walls of the pipe, drill holes and cover it with a grid of stainless steel. The resulting design will score in the ground, then clean the sand from the pipe.

The deepening of the well by the method of dugout should be started with the full impletion of water. After that, with the help of the stairs, it is gently down to the bottom and start pinching the ground under the rings. Due to the decrease in the density of the soil, the rings will begin to gradually settle down, released the place for mounting the new rings on top. Once the places for installing one ring will be enough, it is necessary to be taken for its installation. After installing the ring to the place again, take it over the shovel. The recess must be carried out on 2-3 concrete rings. Extensive soil from the well remove with a bucket and winch.

When all the work on the deepening of the well is completed, make it clean. Thoroughly flush the inner walls of the well rings using a high pressure washing, after which the disinfection of them using a special means, for example, sodium hydrochloride. Then gently close the existing cracks and potholes. It is best for this to use a special mixture made of cement and liquid glass. To water from the well pleased you with your quality and cleanliness, repeat work on cleaning every two or three years.

Now you know that you can deepen the well alone, but if the depth of the well of your well exceeds ten meters, it is better to trust this work to professionals.