How to make a tie from paper?

Origami can overpower anyone. Amazing and beautiful paper crafts will be an excellent addition to any interior of the apartment. Paper can make a great tie that you can give on February 23 or Birthday. In this article you will find the most simple workshops manufacturing paper tie, which will be mastered by even a schoolboy.

1
A classic tie

For the manufacture of paper accessory needed only A4 size paper. If you want to make the tie more or less, pick the appropriate size paper. Optionally, a tie can be ready to paint or paint markers.

Step 1 - of an A4 sheet to make a square, the excess part of the trim with scissors;
Step 2 - exactly in the middle of the square make a bend (bend should get a smooth and clear);
Step 3 - the right and left edge of the square to wrap bend (as is normal paper airplane);
Step 4 - you should have a sharp edge, which you must bend to the middle of the square;
Step 5 - The same sharp element must bend back, leaving up to the edge of 1 cm .;
Step 6 - to make one bend along the line, where the most pointed end (protrusion should turn from a square base approximately 2 cm.);
Step 7 - on both sides of neatly wrapped corners and hide inside (the corners are very small, so be wrapped very carefully, that would not damage the paper);
Step 8 - you should have an element that is slightly reminiscent of a man's shirt with a collar, turn the page;
Step 9 - again folded edge like a airplane, carefully "walk" on all lines bends.

Tie ready!

2
Bow tie made of paper

Bow tie - very stylish male enhancement. If you want to surprise her man an original gift, then take note of our master class manufacturing paper bow tie. In order to get a creative hack need only A4 paper and scissors. Paper is better to choose medium density, so that it was convenient to bend, but at the same time it should be good to keep the shape.

Step 1 - Take a piece of paper and fold it horizontally (if you choose colored paper, you need to bend the sheet back side);
Step 2 - lay back sheet, but the bending line must be well visible;
Step 3 - for precise bending line cut the sheet in half;
Step 4 - the first item is also necessary to lay down horizontally (as done in step 1) and expand back (bending line should be clear);
Step 5 - each corner of the sheet to wrap bend line;
Step 6 - the upper and lower edges of the sheet to wrap the center line of bend (make sure that the end edge coincides exactly with a bend);
Step 7 - fold in half a sheet and a clear swipe the bend (you should have origami, which is similar to the end of the classic tie);
Step 8 - turn obtained element so that its sharp ends "watched" upward;
Step 9 - working with the bottom of origami, fold the two small corner inside (bending line must be clear and visible);
Step 10 - unfold crafts (must turn the element is the same as in the step 6, only the new lines for bending);
Step 11 - bend crafts on new lines of bending and rolling;
Step 12 - are now working with the top of origami wrap the sharp end of 1 cm .;
13 step - corners wrapped inside;
14 step - you should have a very small artifact that must be rotated through 90 degrees;
Step 15 - Take origami both hands and pull the edges in different directions;
16 - You should have a bow tie, right in the middle finger to straighten the bend line;
17 step - the sharp edges of the butterfly wrap inside and make a small crease to give the shape of elegant accessories.