Cheap and simple greenhouse manufacturing for your site is the design of ordinary lumber. Such a structure, if you wish, you can easily disassemble and install without problems anywhere in the garden or garden. Let's first collect it.
1
To do this, prepare:
bar wooden 40x60mm and 30x40mm;
screws bolts for connecting parts;
film with a thickness of 0.3mm greenhouse;
twine, pegs and roulette;
trimming water pipes with a length of 40cm and a diameter of 38mm;
reiki;
nails.
2
We start work. The size of the greenhouse depends on the width of the deployed canvas of the film. With a two-meter width, the length of the greenhouse is covered with two corresponding segments. Thus, with a "roof" skate, equal to 30 degrees, the width of the greenhouse will be 1.7 m at its height of 1.4 m.
3
Platy for greenhouses are broken with roulette, twine and pegs. At the corners and the perimeter of the future design you need to drive pieces into the ground with a step of 80cm. Their segments in 5cm are left over the soil, the racks made of wooden bars are inserted into them.
3
Then, in each rack, it is necessary to make rugs on the ¼ thickness of the bar and fasten the lateral longitudinal rails. All joints should be on the rack. Next, two central racks are installed in the same way. Their tops need to align and attach the skate rail to them. Stropile racks after they were stored on the place. Cross rails are also installed from the frame of the frame. Everything, frame ready.
4
You can pull the film on our facility. To part of the frame on the side of the "roof" with the help of nails and thin rail, a film canvas is nailed. On the north side of the carcass, the film is attached to all Bruckam and Rakes, and its bottom is attached to the soil. To raise the film from the south side, pockets are made at the edges of the canvas. This can be done with a hot iron or industrial hair dryer. Pockets are skipped in pockets.
5
For winding the film when opening our greenhouse to the bottom of the canvas, it is necessary to secure the bobbin. It is made from 30x30mm timber. For fixing, the bobbins are clogged with three piles near the middle and extreme racks. The ends of the greenhouse also abyss the film canvase. Now that the greenhouse is closed, the entire film, covered with the ends with twine, is quite tightly tightlying the bars and the racks of our facilities.
Everything, work is ready. In order to do not confuse its details when transferring it, the nodes of the collected wooden frame is better to mark the marker. Good luck to you in the cultivation of healthy vegetables or beautiful colors!
0
1564
