How to make a greenhouse from polycarbonate

The greenhouse of polycarbonate is durable, spacious, for a long time, in general, the dream of any crop. How to make a polycarbonate greenhouse with your own hands?

It is necessary to prepare polycarbonate sheets. In order for the dirt, water and dust in his cells, due to which transparency is lost, it is necessary to close its edges with a P-shaped plastic profile. Note - sheets produced 12x2.1 meters.

Setting the base. We make the marking of the greenhouse with the help of a cord (rope) and dangled pegs. Garden brown make 4 holes along the greenhouse length 120 cm deep, from the end to make 2 holes at the distance of the door width. Cut asbestos-cement pipes on a piece of 130 cm in size to set vertically into bored holes. Slops fall asleep with sand, tightly tamper. Brux cut into the same segments of 150 cm and sharp the ax to the diameter of asbestos-cement pipes.

Build greenhouse walls. Speed \u200b\u200bwith a protective impregnation post, install in pipes. From the smooth-shaken boards, you need to knock down the frame for the greenhouse. The framework will thus close in the lower part of the support pillars. For the roof make a rafter frame and cover it impregnation for durable protection.

We carry out the installation of polycarbonate. Next to the bottom of the carcass Galvanized ribbons with a width of 25 cm. After that, we sew the side walls with polycarbonate sheets. We make the lip of the roof, so as not to register the water from the galvanized ribbon inside. To do this, cut the tape with a width of 15 cm of the desired length and bending at an angle of 130 degrees. Then we sew the end walls with polycarbonate, we only leave the doorways for the door.

Making doors. Boards dissolve in half with a saw and make a frame of them, it remains to fasten the loops. Now we put a polycarbonate sheet to the door and cut it into size with a knife, then screw it. We hide the door, kpripim to the door fixing hooks and pens.