If you decide to disassemble the moped to parts, go to this issue organized taking into account the moped device and the relationship of its parts. This article will help you.
1
If your moped model is equipped with plastic facing, start disassembling from it. To start, unscrew the trunk (if any), then release from bolts and remove the back of the back of the moped. Remove the saddle after having previously freed from all mounts, then you can remove the back wing of the moped. Start the front facing. Having twisted the bolts, remove all parts of the cladding, as well as the front wing.
2
Remove the benzobak before you do not forget to close the fuel tip. If you have it in the seat, just remove it along with the saddle. If the tank is in front of, unscrew the bolt that holds the benzobac and is closed with a seat, key number 8. Then remove the hose going to the carburetor. If gasoline remained in the filter, carefully remove the hose and instantly shut it with any plug. Now pull the tank on yourself and up.
3
In order to remove the muffler, Loosen the screws attaching it to the frame. Then unscrew the nuts covering the muffler's nozzle with the cylinder, then finally unscrew the bolts on the silencer and carefully remove it.
4
Remove the wheels. To remove the rear wheel, unscrew the axial nut on the 17th key. The wheel is slightly lifted and shake out with your right hand, and left the wheel axis at this time. The liberated on the right of the sleeve also set aside. On the left loosen the Ishko key number 10. Then remove the brake pads, for this, on the left by turning the movements "there and here" pull them out of the axis. Now remove the wheel with the "asterisks".
5
The front wheel is removed easier. To start, unscrew the nut. Lift the front part of the moped to the plug and select the axis with a key or any other submitted tool. Holding the wheel, unscrew and simultaneously pull the axis. Screw to it twisted earlier nuts not to lose. Now jerk up for the plug and pull the wheel at this moment.
6
Let's start dismantling the steering wheel. Here is the entire moped management system: right handle can adjust the speed and activate the front brake of the moped, left - rear brake. Therefore, first of all, unscrew the mounting brackets and free all the cables. Disconnect the headlights and signal indicators, unscrew the rearview mirrors. Making sure that the dashboard is already autonomous, unscrew it from the steering wheel, and then remove the steering wheel. Now you can free the front suspension - a plug with flexible ends.
7
Remove the carburetor. For this key number 10, unscrew the two nuts on the left, then free two symmetrical bolts connecting the carburetor with the head. Now remove the gasket that was between them. Then, unscrew the needle from the carburetor from the top, while keeping it in your hand.
8
Now the engine time. Drain from it Oil, remove the ornamental engine lining. Disconnect all wiring. Remove the cap from the spark plug and unscrew it. Then OT.connect the clutch cable by lifting the frosting lever as high as possible. After that, removemotor chain of moped (you need to find and open the lock on the chain). Unscrew the last two bolts and remove the engine. The rest of the remaining compounds are also discredited and released made a moped.
Surprisingly, everything is extremely simple! It is important only to actually and consistently act according to this instruction.
0
1053
