How to disassemble charging

To brighten the way to travelers, as well as use the navigation system or fix the tracks of the route by the registrar, without a car charger, working from the cigarette lighter, it is difficult to do. But the fuse burned down, and it will take this device to disassemble this device.

Inspect the charger and set the type of connection parts of the case among themselves. All work on light surfaces, or shook the surface with a white sheet of paper to inadvertently not to lose small details that can be sneaked in inorright hands.

Consider a connection with the help of screws with a crossed hat, just being present on some car chargers. You will need miniature watch or telephone screwdrivers, in this case - the cross. We begin to unscrew carefully and without strong pressure, so as not to damage the fragile bolk thread. You can pose a hat with a needle, if you notice scrolling.

In the cast charging device, where the connection is declined, it is easier to get to the internship. We are promoting the top, which is inserted directly into the car cigarette lighter, and if the ring is strongly fixed, we use it. In some charges, the ring on the path to the fuse is missing. Pull the fuse. If you need to fully disassemble the charging, then we put the housing between the palms and open it into two parts, picking up on both sides with your fingers on top.

Replace the burnt fuse new. In case of emergency repair, you can use the wire, but it is very unreliable. It closes the connector contacts for the fuse.

In order not to do on the road to engage in forced repairs with the help of a wire, which to all of the time, can lead to a short circuit, stocking fuses. But also consider that the chargers with a fully cast case are not subject to repair and are disposable.