How to clear the blockage in the toilet

Torget toilet bowl is a fairly common problem, and sometimes it is quite difficult to correct the situation on your own. But if you know what means to apply and how to act, you can easily restore the operation of the sewer system. The use of certain methods depends on the severity of the situation.

Try to make a spray hole to the toilet bowl with hot water. Pulling should be carried out from a high point, quickly and at right angles to create a strong pressure. If the water began to leave, pour hot water into several goals. This method is effective with small blocks. Soda sewers perfectly - Sprinkle half the packs and wait 30 minutes. With no change in the situation, it is worth resorting to a chemical method.

On store shelves there are a lot of means that eliminate blockages, but most of them are ineffective, since they are calculated to eliminate blockages in the sinks. Chemical remedy must be pouring into a hole of the toilet and leave for 2 hours. Then pour the bucket of hot water.

Mechanical methods are the most effective, although not the most pleasant. Common device that is used - Vanutuz. Choose a rubber bowl with a diameter of 10 cm. If there is excessive water, it is better to remove it so that the water covers only the lower part of the rubber bowl. Install the vehicle into the drain hole and pump up the energetic movements up-down. Instead of a vehicle, you can apply a homemade tool: rags fixed to a long stick, cut down the lower part of the plastic bottle.

A flexible cable is a rigid axis of thick spiral wire with a rotating handle. The end of the plumbing cable is lowered into the toilet hole until it stops and start rotating the handle. At the same time, the cable is pushing into the hydraulic scatter and passes all the bends. When overcoming pipes, the end of the cable can be stuck in the back of the bowl. If this happened - just keep screwing the cable.