The use of lubricants between the driving metal, rubber and silicone elements of the suspension and other aggregate nodes is the initial task to extend the service and the fragible operation of the vehicle.
What is needed to replace lubrication?
To properly use lubricant, it is necessary to preliminarily evaluate the degree of production of work planes. An excellent example can be a car silver with a mileage of 30-45 thousand km.
To replace lubricant, you need:
- Remove the remains of the old lubricant.
- Treat surface degreaser.
- Delete clip with bearings.
- Fill all planes with lubrication.
- Install the existing bearing clip or new.
- The inner plane of the anther fill with lubricant to prevent moisture penetration.
- Clamping the outer part of the anther Khomom.
Removing the old lubricant is the most important stage, since as it heats it loses its properties. Sometimes, even solid fractions without metal impurities are formed on large runs. Consequently, the development increases with the machine.
How to use?
Before applying the lubricant to the item must be prepared. It should be brought to the operating temperature (from +7). The higher the temperature, the higher the fluidity of the lubricant. The inside of the shrus itself should also be at least 10 degrees. Otherwise, the necessary fluidity is not achieved to fill the stubborn planes.
Thus, the inexpensive lubricant will help extend the service life of the drives by 10 or even 20 thousand km without replacing them. All work takes up to 30 minutes.
0
569
