No matter how you remove the old coating, it is still a dirty job. That is why you have to prepare to prepare for the upcoming time processing process before sticking wallpaper. Find the old unnecessary clothing, take care of the safety of things and restricting the access of dust into clean rooms, as the construction trash has the property quickly spread. To work with chemical preparations prepare rubber gloves and safety glasses. Hair must be hidden under the headdress.
Before starting work, remove all the furniture from the room. If such an opportunity is not foreshadowed, slide the center at the center of the room and cover the covers. Ship the floor and prepare packets or other garbage containers. Using chemical brokes, carefully read the instructions and strictly follow all these recommendations. Be sure to open the windows for sufficient air ventilation and keep the required time to maximize the result.
- Apply the required amount of chemical solution on the walls and distribute evenly with a brush. During the time specified in the instruction, do not touch the walls - the solution must be soaked for mitigating texture and light removal.
- After the softening paint, carefully remove it with a wide spatula, do not forget to wear glasses and gloves.
- To remove paint residues, use a wire scraper, pre-moistened in a coil liquid.
- Remove texture paint based on a powder or a special mixture with a steam generator that softens the coating. Never use eaten paper in such cases.
- On the surfaces, partially designed by ceramic tiles, start working from the edge. On the fully lined wall, break one of the tiles with a hammer. Use a wide stone chisel and a hammer to knock down the old tile from the wall.
- Removing the wall panels, pay attention to the last plan - it is most often nailed to the crate of nails. Using a hammer and a beard, remove the board from the wall. The rest of the boards are usually fixed with nails crashed through the swing ridges. Opening the boards from the crate, use a small scrap-mount, trying not to damage the wall. After removing the crate from the wall. Use the hammer-nail: pulling out nails, put unnecessary trimming under it.
- Abundantly moist the wall with water and let it be soaked. Literally in 10-15 minutes it will be possible to consider old wallpaper with a wide spatula. For better effect and quick results, add a little detergent or special fluid removal fluid into water. Some wallpaper after removal leave the paper base. If the base holds well on the surface - this is a plus.
- Remove the remaining wallpaper pieces is more convenient than the whole piece of sandpaper, stretched on a wooden bar.
- If cracks have been found in the repair process - close it with a mixture of shtklanie with cellulose and cover the stable spots with a special primer.
- Apply a layer of glue to a new plaster - such foresight will prevent the rapid moisture absorption.
- Usually, the inlet paper is glued horizontally along each of the walls to prevent coincidence of seams on paper and wallpaper. Otherwise, they may disperse as soon as the glue is dry.
- If it facilitates the work, then the inlet paper can be glued vertically in narrow niches or for pipes and if you are going to paint the wallpaper, because then the joints will be less noticeable.
The final result depends directly from the initial level of wall preparation. If you wish your home reminded the creation of the hands of a skillful wizard, do not be lazy to make preparatory work before pasting wallpaper.
0
1167
