Drivers tint car glass not only to improve the appearance of the machine. Tinted film safety films are played by a big role: help to keep the glass, it will not fly into small pieces when they hit, protect against ultraviolet rays, reduce the brightness of the reflections from snow, bright headlights of the counter car and sun rays. Thanks to the tinted windows, the interior of the car is protected, because under the influence of direct sunlight, the casing will be burned out, plastic parts are spoiled.
1
If it was decided to tonodize the glass yourself, the main thing is accuracy and attentiveness. It is best to do it on a cloudy day after the rain or in a clean room to avoid dust. The main thing is to choose a good toning film. It should not be too dark and mirrored, as the fines are provided for it. The windshield is prohibited to tint. Do not save on the film, high-quality tinting will last for many years.
2
The next step is the cutting film. Before proceeding to this, it is necessary to apply toning to the wet glass. The film sticks well and at the same time easily removed. Sometimes folds may form, since the windows of the car have a curved shape in this case, you need to apply a film to the glass, smooth the scraper, and all the excess air bent to the middle and move up or down. Next, the resulting buccorcle is heated by a hairdryer until a complete disappearance. After that, the film is cut. At the edges, make a stock of 5-10 mm. It should be greater if the glass is descending. The film is cut rough, but very neatly, as it can be easily damaging. You can use the usual polyethylene film, and then transfer the pattern to tint.
3
After it is necessary to wash the car well, pay special attention to the windows. It is recommended to use the detergent for dishes - it is less than a divorce. An ordinary shampoo is also suitable - it neutralizes the adhesive on the film. The rags are not used, the water is driven by a scraper. The windows of the car on both sides are clean.
4
When all the preparatory work is completed, you can proceed directly to sticking. The film is applied to the inside of the automotive window - it is less susceptible to damage. First, the corner is glued, then the protective film is neatly removed from under tinting and simultaneously pressed against the glass. When all the toning is glued, it is necessary to smooth it with a special sticker. They are also driven by air bubbles and the remains of a shampoo. Since glue is neutralized with shampoo for 20 minutes, you can still move the film.
5
The upper protective layer is removed and kept dry for a day. Some toning films go only with lower protection, in this case you need to very carefully smooth it with a sticker so as not to leave scratches.
The quality of sticking depends on the materials and dexterity of the wizard. If this is done for the first time, it is better to practice on a cheap film or a piece of trimming, to understand exactly how to smooth out and how the neutralization of glue passes.
0
1663
