The cellar is a mandatory construction in the country area, a nice farm or in the garage. Long-term storage of products is provided by the competent device of the entire design and overlap in particular. One of the embodiments can be a monolithic plate, cast directly in place, the process of its manufacture is considered further.
1
List of essential materials:
Steel profile;
Boards and bars;
OSP or other sheet material for formwork;
Metal fittings;
Brick red;
Rolled waterproofing;
Plastic pipes;
Ceramzit;
Concrete mix.
2
First, pieces of profile are stacked on the walls of the cellar, the distance between which depends on the metal cross section, usually 60-80 cm. Then the formwork from OSP sheets is then screwed down. In different angles, the cellar is made of the installation of ventilation pipes in pre-cut holes. A plate formwork is installed around the hatch. Given the large mass of the reinforced concrete, the backups are necessarily installed.
3
A binding of a double reinforcement frame is performed, based on the thickness of the plate at 20 cm. Now you begin to the fill of the concrete, which should be carried out with a uniform layer without stopping, until the entire overlap is fully filling. In the process of the fill, you should drive out air from the solution using a vibrator or remedies (timber, shovels). Next, the works are suspended until concrete drying.
4
A layer of waterproofing is made around the entrance of the brick's inlet of the brick, the layer of waterproofing is arranged, the overlap is insulated with a clay. Further actions depend on the selected floor design in the room above the cellar. It can be a concrete fill or a wooden coating. It remains to make the hatch lid and a comfortable staircase.
A favorable microclimate in the cellar also depends on the correct ventilation, it is possible to obtain information about it by viewing the video instruction.
0
4957
