Siding is a cladding panel for cladding facades. There are the following types of siding: vinyl, cement, ground, aluminum, steel, ceramic, wood plates, plywood paneling. For the installation of siding required:
Fasteners (screws, nails);
Roulette;
Siding and profile;
Carpenter's tool;
Level;
Wooden rack size 40h60mm;
plummet;
Electric drill.
1
It is necessary to remove the old trim, shutters and trim. Wooden houses should be caulked with oakum, lnovatinom or jute cord. All holes zapenit with foam.
2
Sheathe siding in the vertical direction. Step bearing elements to calculate the recommended way to get a quality design and tough. It is necessary to prepare in advance a finishing material, it is important to know the height of the frame.
3
Hammered onto the walls of the grate wooden slats 60x40 mm vertically arranging them in increments 40x30 cm. Additionally nailed lath at the inner and outer corners, around window and door openings. Plumb need to check whether the same plane is the outer surface of the rails. Excess can podtesat plane. Where not enough, on the contrary - to put a rack of scrap boards.
4
Making the measurements of the house to calculate the necessary amount of siding. Received multiplied by 1.1 (the loss factor in trimming and adjusted material), we obtain the amount of material. Next you need to calculate how many standard profiles will mount.
5
On obreshete anchoring standard profiles (okolodvernye, okolookonnye, connectors, etc.). Take the tools - the level and plumb, check the horizontality and verticality of the surface of a standard profile. Along the perimeter of the wall in the bottom of the sump and the initial anchoring profiles.
6
Siding fastened aluminum, galvanized nails and screws with an anticorrosive coating. Cap should have a diameter not less than 1 cm. The cutting is carried out via the panel Jig saws and metal. Attach siding needed at a distance of 37 cm.
7
Siding Mounting: For the protrusion, it is necessary to hook the bottom edge of the siding panel by pulling up, connect to the bottom panel, then fasten the top edge of the plank to the slacks. Between the screw screw and the bar, leave 0.5 to 1 cm. You should also provide an end gap between standard profiles and panels (in winter 0.8-0.9 cm, in summer 0.6 cm). If you do not leave the clearance, then in the future, siding can deform or break the facing.
Thanks to Siding, the house will acquire a decorative aesthetic appearance, he will also warm and keeps it from exposure to climate.
Share advice:"How to shepherd wooden house siding"
0
1292
