Such a service as a call to customize the receiver is expensive. Many simply do not want to let out of a foreign person in their house and try to set up digital television independently. But, if you absolutely do not understand the settings, our article will help you easily correct this problem and configure the receiver without difficulty.
Why did the signal disappear?
If you have already been configured the receiver, but suddenly the broadcasting disappeared and the message "No signal" appears on the TV screen, do not hurry to configure it. The case may not be in the receiver settings. There are several reasons why the signal can be lost:
- the cable that connects the antenna with the tuner;
- technical works are carried out (it is necessary to call support and to ask the operator's work);
- satellite antenna settings were shot down.
If you are confident that the case is in the receiver, first of all you need to restart the tuner, just do not turn it off using the off button on the control panel, and pull the power supply from the socket and turn on the re-1 minute. If the signal does not appear, then you need to go to the "Tuner Setup" item.
General Receiver Setup Rules
Since the receiver models are a lot, then the settings for each are very individual. First of all, check out the instructions of your tuner. If you do not know the exact model of your receiver and can not find the instruction to it, you can configure it, following step-by-step instructions:
- 1 step - on the Receiver Remote Control Press "Menu";
- 2 step - select "Language" (may be called different, "Language panel", etc.) and select the Russian language, click on the "OK" panel;
- 3 step - again press the "Menu" and go to the "Installation" section (for all tuners this is a standard name);
- 4 step - you should open the context menu, where you need to enter the settings, 1 item - "Country Setting", choose Russia (or another country whose channels you want to watch);
- 5 Step - in the "TV Signal Standard" section Select T2;
- 6 step - go to the "Autopoyscript" section and click "OK" (so you specify the Tuner automatic channel search);
- 7 Step - If the number of channels did not suit you, then you need to go to the "Manual Setup" section (located in the Installation Point and go to manual configuration, after each channel found, click "OK", so you will save settings).
How to check the operation of the receiver?
When you configured the tuner and saved all changes, you need to check. Make it very simple:
- 1 step - turn on the TV and tuner with two remote controls;
- 2 step - on the tuner's console, press the "Info" button (3 times), usually this is a yellow button;
- 3 Step - Pay attention to the percentage of the "signal quality" and "signal level" if the digital indicators are more than 60%, then you are fine tuner and you can enjoy watching your favorite transfer.
Now you have read how to configure the receiver. If you have purchased a used prefix or you were initially configured incorrectly, then you need to reset the settings to factory and start the installation again, as described above.
0
439
