What is needed to watch Digital Satellite TV "Tricolor TV"? Familiar to everyone satellite antenna - "Plate" and supplied to it equipment - receiver (or tuner) and convector. If you have already installed the antenna, the next step is to connect it to the TV through the receiver.
1
Take a look at the rear panel of your receiver. LNB IN connectors are located there - connects to the convector, LNB OUT - is intended for the high frequency antenna cable, the connector for the power supply, as well as, depending on the model of your tuner, SCART, HDMI or Tulip. Since the range of receiver "Tricolor TV" Very varied, the set of available connectors can differ significantly. All listed outputs may be present, but a variant of the presence of one thing is possible. USB output is designed to update the tuner software.
2
Pay attention to the available differences in the receiver firmware. Some firmware versions allow you to broadcast images to all outputs, others will offer you to choose which output will go to. Therefore, depending on the technical characteristics of the tuner there are several ways to connect to the TV.
3
So, regardless of how the cable you will connect the receiver and TV, take the antenna cable and connect to the LNB in \u200b\u200bthe tuner jack.
4
If you are planning to use a high-frequency cable, connect via the LNB OUT output and the antenna TV connector. Turn on the receiver and TV. The fact that the receiver earned shows the inscription "BOOT" on the display of the tuner. As soon as the channel number appears instead of this inscription, search the channels on the TV until the "No Signal" appears. This means that you have connected the receiver correctly.
5
Similarly, the SCART - EXT, "Tulip" - AV or HDMI cable is connected. Using a television remote control, select the desired type of incoming signal - AV, EXT, HDMI, sequentially pressing the "Sourse" button (or "TV / AV" on the high-generation TVs) until the inscription appears "no signal". Connection completed, left to adjust the antenna.
Connecting carefully because the most common problem at this stage is incorrectly selected cable connectors. If you have any questions, seek help from the Tricolor TV specialists or use the information on website.
2
5679
only you helped))) thanks
And if there is an LNB in \u200b\u200binput on the TV, connect the receiver there or still in Ant in?