How to set up Tricolor.

How to set up Tricolor.

The company Tricolor TV, in addition to broadcasting satellite television, offers services for connecting and configuring equipment. But you can do it yourself, which is not at all difficult, sticking to the next instruction. At the same time, you will save on the call of a group of specialists.

1
A good signal depends largely on the correctness of the selected place to install the antenna. The main requirement is the absence near high-rise houses and trees that may interfere with the passage of the signal. If you live in the lower floors of the altitude, and a few meters from the windows there is a neighboring building, will rationally be located an antenna on the roof. In no case place the device in your apartment or on the balcony.

2
The next step is to collect antenna design according to the instructions. Secure the bracket to the surface of the wall using the most suitable fasteners. These can anchor bolts, screws, self-tapping screws or studs. The receiving device is mounted in the holder of the connector down so that in the future it does not fall into it. The cable is connected to it and is necessarily tightened by the tie on the arc on which the receiver is installed. Depending on the region and the model, it is necessary to regulate the "plate", turning it at an angle.

3
Connect the cable to the TV. Next, the settings will be carried out using the remote control. Turn on the TV and go to the Main menu section by clicking the "MENU" button. By default, the Russian language should be displayed. Go to "Settings", then in "System Installations", enter the current time. In the "Satellite" string, depending on your region, the name must be selected. It can be EutelSat 36A, EutelSat 36B, Bonum-1 or DirectV-1R. In the column "Search type" set tricolor TV.

4
After selecting the satellite, click on the "OK" panel. As a result, two scales are displayed - the level and quality of the signal. With the correct installation and correctly the above-mentioned actions, the scale should show no less than 70%. Otherwise, the angle of inclination of the antenna mirror should be changed. Adjusting the position, keep a few seconds to change the signal to change.

When you finish the setting, do not forget to tighten the fastener and be sure to save the settings before going out the menu. The signal level may deteriorate during rain, snowfall or strong wind. Do not forget to clean the antenna from snow and dirt.

Add a comment

Your e-mail will not be published. Mandatory fields are marked *

close