The method of fastening PVC panels depends on the type of crate and from the state of the surface. The panel shawlock is fixed with the help of brackets, small screws, klimmers. On a flat surface glued.
1
The gluing panels directly to the base surface has its advantages. The size of the room is reduced only on the thickness of the panel, and you do not need to spend additional funds for the purchase of materials for the crate. If the ceiling plate drop is more than 2 cm, the installation of the crate is required. That glue firmly clutches with the surface, it must be prepared. Remove the blots, old wallpaper. The loose plaster that crepts, treat the primer of deep penetration. Weight surfaces to cover the surface - the surface should be smooth. After grinding again to drive again. After waiting for the complete drying of the primer, proceed to sticking the panels.
2
For mounting panels There is special fittings. Corners and profiles hide the cropped parts of the panel. Muffy enough elements with a dowel. For gluing panels, use liquid nails or titanium glue. It is convenient to combine both types of glue. On the surface of the panel dots or zigzag, apply titanium, and on the shelves and the upper and lower parts - liquid nails. Give glue a little grab for 3-5 minutes. Shelf panels Write in the profile and tightly press to the surface. Pollution with the front part remove with a wet sponge. The shelf of the next panel is inserted into the groove of the previous one.
3
Clammers or clips allow you to dismantle panels without damage, because When installing do not disturb the integrity of the shelf. This method of attachment does not interfere with the temperature elongation of the material. Clammers are attached to the crate of nails or self-drawing, then install the panel. The second way - you first need to wear a whirlwind on the inner part of the panel of the panel, then fix the panel on the trint of nails or screws.
4
Installation of the aluminum profile frame allows you to install point lamps. The elements are fixed to galvanized screws with a press washer with a 4.2x16 mm. The use of glue to fix the material to the metallic profile is permissible only on vertical surfaces. Make sure that the shelf panel evenly entered the groove of the previous one. To do this, it is enough to pat on the edge of the panel. Holes for lamps and sockets should be cut in advance.
5
For mounting panels on a wooden crate, it is convenient to use stapler with brackets. In rooms with high humidity, a wooden bar is deformed with time, so it is better to use an aluminum profile for a frame.
Plastic PVC panels do not require constant care. With the right installation, they will serve you for a long time. Use for fastening the curzmers - if you want to update the interior of the kitchen or bathroom, the old panels will be suitable for finishing the country house.
0
1944
