No house is safe from the heat. A lot of heat is lost through windows and doors. Modern windows can significantly reduce the loss, but the doors that can not boast. can successfully cope if insulate the door with this problem. To learn how you can do it, we will tell in this article.
How to warm front door inside
This method is preferable for the metal doors and under the force of each. inside need for thermal insulation:
- insulation (mineral wool, polystyrene, etc.);
- decorative panels or slats;
- screws;
- wooden beams;
- pencil;
- yardstick;
- saw;
- screwdriver.
All actions are performed in the following sequence:
- Remove the skin from one side of the door.
- With wooden beams assemble crate.
- After that lay the insulation in the resulting cells.
- Now you can sheathe the door racks or decorative panels.
This method is good, but can not completely reduce heat loss. All the fault of metallic structure doors, as well as accessories. Therefore we can use the second method, which may be in addition to the first.
How to insulate the door with the help of foam, batting or felt
This cladding door from the outside (from the street or the entrance). For this you need:
- insulation (batting, felt);
- leatherette;
- glue;
- decorative studs.
Progress is quite simple. On the door leaf to apply the adhesive glue and a layer of insulation. You can then obtyanut door leatherette. Better to start from the top. Anchoring material, and then gently pulling hook it on the sides of the door, and finally the bottom. Thereafter, additional anchoring leather over the entire surface of the door leaf ornamental nails. If we apply imagination, you can create a drawing. This method of insulation is indispensable for wooden doors.
How to insulate the door from drafts
- The insulated door holds more heat in the room. But also need to be convinced of the absence of drafts. They can form when the door to the box does not fit tightly. It is easy to eliminate with special seals. They are released from foam rubber and rubber on self-adhesive basis. In place of contacting the doors and boxes, it is necessary to clean everything well from dust and dirt. After that, we take the seal and carefully, removing the protective film from the adhesive layer, we glue it to the surface on the sides and on top of the box. You can also stick it to the door. So you will provide a dense door closing and remove the draft.
- Also can blow from the space between the opening door and the box. This is more time-consuming work, but not complicated. To do this, you will need to remove the slopes and clean the old insulation. After that, lay a new material and set the slopes into place. Taking advantage of these methods, you will achieve an increase in the temperature in the apartment by 0.5-1 degrees at least. And also eliminate drafts.
The article describes the methods of insulation of the entrance door. Practical advice and necessary materials are given. Taking advantage of the tips of the article, you can eliminate heat loss in your housing. Successful work.
0
2048
