Each driver understands that using the car, sooner or later you have to repair anything. Therefore, a quick inspection before the trip for many remains a good rule. And if stains from oil under the car are found, it can cause anxiety. Since the problem of the oil leakage is faced with the problem of oil leakage. And in such cases it is not necessary to immediately go to a hundred. Knowing your car, you can delete the problem without the help of specialists. With this without spending money for repairs. What can cause oil leakage and how to fix the problem?
1
The case may be in rubber seals located in the power unit. Over time, they lose their elasticity, which leads to the problem. From time to time, browse them and replace if necessary.
2
Clear ventilation can become another reason. The exhaust gases can make their way into the engine crankcase, if it is not new. Accumulated gases lead to extra pressure.
3
Therefore, to eliminate any leak of oil from the engine, the crankcase ventilation system is important. It should work perfectly and without interruptions.
4
Flowing oil from under the valve cover? To fix, you need to remove the lid. Clean her, and the gasket is carefully lubricating the sealant and put the lid where it was.
5
In the situation of inclination from the oil filter, you need to tighten it rigorously or, if necessary, replace.
6
So that the oil does not flow at the place of the traver, do the following. Eliminate the lid by removing the fastening bolts. Then wake the place of dusting with a sealant. Next, put a rubber in its place. Important moment: It is necessary that the runner itself was in the same place as before eliminating.
7
Lands of oil can form in the pallet of the motor crankcase and the checkpoint. To eliminate, you need to remove the pallet itself. If deformation is detected, to carry out restoration work, applying sealant. Put the pallet in your place. It is worth noting that when installing a pallet, most drivers use exclusively sealant. And there are those who also put the gasket.
8
The most laborious work to eliminate oil leakage, if it occurs under the crankshaft seals. In this case, you need to disassemble the motor and replace the seals. Using the sealant. They lubricate the shaft and the surface of the seals, which is considered a worker.
It is possible to correct the loss of oil in most situations. Of course, there are cases when it is worth going to a hundred to fix the breakdown. Therefore, you should not neglect the inspection of the car before the planned trip. It will save not only time, but also money.
14
3393
