The design of the hive lounger allows you to quickly increase the number of bees, warning the rose. In winter, it can contain 2 families separated by a thin partition. They will warm each other, and, it means to consume less honey.
For the manufacture of lesions, it is necessary:
roulette or ruler, square;
boards;
hacksaw;
hammer;
drill
chisel;
fittings and fasteners.
1
For the hive, the wood of soft rocks, with a humidity of 15%. A spruce, non-resinous pine, fir, cedar suitable from coniferous. From decade, stop the selection on Lipa, IWA, topolate.
2
Decide with the capacity of the hive. Standard Hives Sunbeds are designed for 16, 20, 24 frames. Under the abundance of honeycombs put an additional store frame.
3
Details of the hive should be treated with high quality, with minimal deviations from drawing sizes. The hive collected from inaccurately manufactured parts will be selected, and it is harder to work with it.
4
The first is going to the bottom. It consists of 2 speeches and flooring. The boards are connected to the spool, and come back with nails. Ready bottom is checked for compliance with the size of the ruler and the corner.
5
The side walls are connected to the spool using nails. The side walls are attached to the bottom with a protrusion of 20 mm for bars.
6
To assemble the housing (front and rear wall), a board is 750 mm long. In the upper boards, it is necessary to make a groove for the 38x11 mm frames. In the lower chalkboard, 1-2 recesses with a length of 200 mm high 20 mm height under the pilots are cut. On the side walls and the bottom of the boards are attached nails.
7
Before the summer nails, consolidate the flight board and the valve.
8
For a frame roof frame, 80 mm width are knocked down with nails in spike. The flooring boards nourish the frame across. On top of the roof to sheathe the tin, rubberoid, etc. waterproof material.
9
Ventilation. On one of the substrates (closing frames), a hole is drilled 3-2 cm. From the back of the roof, a slot hole 200 mm long, 3 mm wide is dried. Hole on the front of the roof round - 25 mm. On the inside, the ventilation is closed by a grid.
10
Before the painting hive is grounded with oil. The housing is grounded from the outside. Roof and bottom - with inner and outdoor. For ease of carrying on the sides of the hive, handles are attached.
In the manufacture of hives, leave a small allowance. Then, in case of errors, the skew can be eliminated.
0
2945
