Installing the desired height of the steering column can help relieve back pain, wrists and hands while driving. You can adjust the height of the steering wheel yourself, having adjustable (wretched) and hexagonal keys at hand.
How to raise a steering wheel on a bicycle - we will determine the design
The steering wheel adjustment process depends on the bicycle model, which has a threaded or reversal structure. The set of the first column consists of bearings, a steering tube and other components that hold a fork and steering wheel, allowing them to rotate smoothly. The rear -line design of the steering wheel is fixed only by clamping bolts.
How to raise a wheel on a bicycle - what do you need
- A set of end keys.
- Divorce wrench adjustable to 40 mm.
- Light bicycle oil.
- Steel hammer.
- Sending rings (size according to the diameter of the rod).
- Rag.
How to raise a wheel on a bicycle - a threaded steering column
The threaded column represents the wedge-fixer, which leaves the frame, leaning forward, and then attached to the steering wheel to the steering wheel. In place, the column is held by one central bolt at the top. Such a steering wheel is installed on old brands of bicycles that have one speed and fixed gear.
- Click the front wheel of your bike with your feet. Loosen the wheel of the steering wheel with a wiper (usually 6 mm or 8 mm) or adjustable wrench.
- Twist the steering wheel from side to side, pulling up. If it does not move, weaken the nut around the base of the pipe with a divorce key and moisten with oil. Wait five minutes, and then slightly hit it with a hammer and try it again.
- Pull the calm-fixer completely from the pipe. Wipe it with a rag and apply a thin layer of grease.
- Insert the lock by installing it to the desired height. Do not raise the wedge above the maximum level, which is indicated by the horizontal line on the pipe.
- Tighten the bolt, holding behind the wheel, leaving it in relation to the front wheel.
How to raise a wheel on a bicycle - an objector steering column
- Use the end key (usually 5 mm) to weaken and remove the bolt on the upper part of the steering pipe, which is inserted into the bicycle frame. This bolt holds the steering wheel on a bicycle, so you need to remove it to adjust the height.
- Weaken the fitting bolts in the upper part of the steering pipe. Slowly remove the steering wheel, making sure that the wires attached to the brakes and switches are not bend. To ensure their safety, it is better to put the bicycle on the table or chair.
- Add or remove additional rings on the steering pipe to achieve the desired height.
- Install the steering wheel along with the screed bolts on the upper part of the steering pipe. Tighten the bolt, while aligning the steering wheel in relation to the front wheel.
- Check the maneuverability of the bicycle. Make sure the steering wheel turns freely. If not, weaken the bolt of the head a little.
When adjusting the steering column, it should be borne in mind that the low height of the steering wheel reduces the center of gravity. Placing more weight above the front wheel, you increase the traction. In addition, the lower height provides the central position of the body between the two wheels, which can improve control over the bicycle during the rises. However, there is a limit; Diping the steering wheel too low, you can make the bicycle difficultly controlled. Fortunately, experimenting with the height of the steering wheel is easy and most often this can be done independently.
0
566
