Knitting is not just a hobby, as well as a way to get rid of tension, this is a kind of psychological relaxation. Many women are fond of this, creating unique things: from small toys to clothes. To start knitting a product or sample, you need to dial the hinges of the initial row. This "task" requires care and responsibility, since the product itself "originates" from the first loop. But very many needlewomen at the initial stages it seems that to score a hinge on the needles is quite difficult. But it is not. Let's deal with what!
Pattern, execution technique and the type of product directly depend on which set of loops you carry out. There are a lot of different options with which it is recommended to read in the future. The first row is the edge of the future product, which is very noticeable, so it must be made as accurate as possible. The hinge set can be done both as one and two threads, and on what method you choose, various edges of products will be obtained. But for "newbies", two simple and common options for the start of mating are recommended.
How to dial loops on the needles - Method 1
In the first way, we propose to consider the option "air loops". We begin in this way: put the knit and end of the thread into the right palm, press the fingers of the left hand (Mysinetseed and Unnight) continuation of the thread, while the free part is left on the index finger. The sharp end of the knitting needles, located in the right hand, move in the direction from the wrist to the fingers under the thread, which is on the index finger. After resetting the resulting loop from the left hand. Now the loop must be delayed. Repeat these manipulations until you gain the required amount of mating loops.
How to dial loops on the needles - method 2
To start knitting, refuse, multiplying two, from the very end of the threads exactly as much as your product is in width. Next, on a large and index finger of the left hand, put the thread and hold the ends. Two knitting needles in the right hand and tide a thread on the wrist direction stretched on the left hand. Spokes turn clockwise. After stretching the needles through the loop, which is on the thumb and drop the loop, while still the same, keeping the threads in the left hand. The loop on the spokes is dragged when you, spreading your fingers, pull the thread in your hand. It was detailed steps only to create the first loop. Without weakening the thread, dial the following in this way:
- Lower the knitting needles that lie in the right hand, a little closer to the wrist. You will notice that the loop was formed on the finger.
- After bring the knitting needles (from top to bottom) into the resulting loop and stretch the thread from the index finger.
- Reset the threads and repeat the same manipulations as for the first loop.
By typing the required amount of loops for the desired width of the product, pull out one needle and begin the work itself.
These are the two main and simplest techniques for the set of knitting loops. There is still a huge number of different ways, but they necessarily require certain skills and skills.
1
1714
