The cartridge reset procedure causes a sense of confusion from many Epson printers. Although this is not such a complex process. Since there are several types of cartridges refilled to print devices of this manufacturer, the procedures of their zeroing can be carried out in several ways.
1
If your printer's PGC has a special zero button, simply display the carriage of the device to replace and click this button without releasing, for 5-7 seconds.
2
If your cartridge is not equipped with such a button, but has two small round contact placed on each other at a distance of about a millimeter, the reset procedure will be somewhat different. Start from the extraction of the PZK selected to zero in accordance with the instructions for the printer. Then take a flat screwdriver and close these contacts.
3
If the PZK on your printing device does not have no zero button, no two contacts in the top of the chip, it is possible to reset it as follows. Get it out of the printer and immediately return back to the place. Thus, zeroing will occur in automatic mode.
4
Regardless of how you reset the cartridge, the final step must be confirmed by the process of replacing the cartridge on the printer panel and the refueling itself. This will help to avoid bringing the head that may occur if the actual ink level in the cartridge will end even before you decide to reset it.
Note that the Epson cartridge reset procedure will be available only after the printing device itself is message about the need to replace the PPC.
If the PZK on your printing device does not have no zero button, no two contacts in the top of the chip, it is possible to reset it as follows. Get it out of the printer and immediately return back to the place. Thus, zeroing will occur in automatic mode. What if after the carriage drove into the original position, did he start writing again that there are no paints ???
0
4343
If the PZK on your printing device does not have no zero button, no two contacts in the top of the chip, it is possible to reset it as follows. Get it out of the printer and immediately return back to the place. Thus, zeroing will occur in automatic mode.
What if after the carriage drove into the original position, did he start writing again that there are no paints ???
So I replaced not the one. I have 8 years old PZK work - there are no problems.
I have a second set of a black cartridge once reset, and everything hangs like empty, not reset, even kill.