How to make boots with your own hands?

Already over the centuries, the boots remain comfortable warm shoes, with which no frosts are scared. They are easy to wear, it is easy to read and also make them easily independently, more details, about the manufacture of boots with their own hands in this article.

1
What is needed for the manufacture of boots?

In fact, the manufacture of boots will need water and wool and very little hardworking. Most of the work is work with your hands.

Warm boots can be made fast enough, for 1 to 2 days.

Six for the manufacture of boots can be used - any, but most suitable wool, which is used to felting products.

We will also need such healthy tools:

- soap water (you can use both soap and dishwashing agents);
- mosquito net or other matterium for felting;
- scissors (more convenient to use the stationery knife);
- waterproof material, you can use a building insulation (some use foam);
- Device for spraying fluid.

2
Production of Valenok.

We prepare a soap solution.

From the construction insulation, cut out the template for future boots.
We prepare the table to felting the wool and the beginning of the manufacturer of the boots: we settle the loaf and the stele diaper.
We take wool and distribute it into small parts, then each part must be pulled out.

When the wool was placed, pulled, put it on the table layers in one direction. Initially, put the strands of the transverse pattern.
Next, we lie to the wool on the first layer, (as if a cross on the cross).

Making an angle of 40 degrees.

Well we can weigh the wool and wet it with soapy. No need to add too much soapy solutions, it is better to add soap water in the process.
We use the napkin, cover it already treated wool, slightly and gently press.

We remove the napkin and lie on the wool the bootable pattern of the flange, which must be cut in advance.

Next, it is necessary to heat the wool along the edges of the template and on top to impose new wool, as it were, filling empty places.

Welcome soapy water and cover the napkin.
We do the same procedure as for the first part of the boots.
All irregularities need to be smoothed, the billet of the boiler must be symmetrical. In the case of holes, you can also add wool and also to be treated with soap solution, as described above.
When the workpiece is ready, it is necessary to cover the napkin again and start rubbing. Special attention should be paid at the places of bends.
When the surface of the wool becomes smooth and not durable, the prepared pattern should be cut into two parts.

Now it is necessary to lose well at the edges of the workpiece so that they become smooth and smooth.
It should be removed the workpiece and continue felting from the inside of the boots.
So that the wool is better to handle, you can use the oilcloth. So wool heats up and the rolling process is better.
Give the felt shape.

If it is impossible to pin down from the boiled booth, then we can assume that the product is ready.
We rinse the boots in the water and put on drying.
Warm winter boots - ready!