The clock with the battery is convenient because they are not required to start. But the battery is not eternal, and after once, some time comes into disrepair. The question arises where and how to change it. In addition, the battery itself is a penny, and the replacement in the workshop will be expensive. Try to explore our recommendations and independently replace the feeding item in your clock.
1
To change the battery, the first thing you need to open the clock. The lid can be twisted and recreated. Look carefully: if the lid is recreated, then on the case in the clock there is a deepening and the cover is required to pick up. Take a small knife or a small screwdriver, insert your tool into the recess and discove the lid. The clock should be kept hard, and press - firmly and carefully, so as not to break the clock and will not be lit.
2
If there is a deepening in a circle on the lid, six to eight pieces it is unscrewed. From those tools that can be a homemade master, the caliper is best suited. Slide it in the width of the labels and tighten the bolt so that the plank does not move. Insert the tool in two recesses and unscrew the lid. You need to unscrew on the left side.
3
When you remove the lid, carefully look and remember how the battery is standing, as it is attached and its polarity. It is important not to confuse "+" and "-". Carefully remove the tweezers (better than plastic) battery. The battery needs to pick up similar. If it is smaller, then there will be no contact, and more will destroy the clock.
4
By inserting the battery, try not to take it with your fingers - better than tweezers. Watch the right polarity! When the battery is inserted, make sure the clock goes, then you can close the lid.
5
The cover that is unscrewed is spinning with a caliper. Before that, you need to check the gasket, and if it came into disrepair, then you need to slightly lubricate the sealant.
6
If you want to close the lid that is recreated, you need to put the clock on the table (do not forget to put the napkin) and cover the lid. Watch the cover to lay, as soon as possible, and the grooves was combined with the axis of the shooter's transfer wheel. Then take a small flat object (preferably wooden), put it on the cover and slightly push through the entire plane. The lid should close without any difficulty.
We hope that by reading our advice, you will succeed, and you will not need to spend time on a hike in the workshop.
Share advice:"How to change the battery in wristwatches"
0
3103
