How to paint the ceiling of water-level paint

High-quality painting of the ceiling of water-level paint is a rather time-consuming process that requires certain skills and knowledge in this area. By adhering to the following tips, you can easily overcome the procedure and as a result you will get a highly painted ceiling without defects.

First of all, the degree of carefully made work depends on the quality of the prepared ceiling. It is important that the surface of the stained ceiling is smooth and smooth. To do this, it is necessary to close all the irregularities and cracks with putty. If the ceiling has already been subjected to any repair work, it will be necessary to remove the previous layer of paint or bliss. After cleaning and aligning the ceiling surface, the primer is carried out, which contributes to uniform staining.

Required Tools for Painting Ceiling:

painting brush for staining of joints and angles between the ceiling and walls;
fur roller with a long pile;
telescopic handle for roller;
paint tray with a ribbed surface.

Free the room from unnecessary furniture and technology. Walls and gender in terms of caution cover with a polyethylene dense film. Some manufacturers recommend diluting paint with water to 10%. Before starting work, be sure to mix all the paint in the bank using an electrical drill with a mixer nozzle.

Painting first of all begins with corners and junctions between the ceiling and wall. Paint brush wettrates paint and pressed from surplus. On the entire perimeter, the ceiling is scratched with a strip of 3-5 cm wide, starting from a long corner. This will avoid further stake in the corners.

The rest of the surface is painted with roller. To do this, a small amount of paint is poured into the tray, in which the roller is wetted. In order for the paint to be distributed evenly along the surface of the surface, it is necessary to carry out a roller on the ribbed surface of the tray, this will allow the paint to completely impregnate the roller texture. The movement of the roller starts from the left corner.

The main rule is to put paint in three stages. The very first stage is performed in parallel incident rays of light, the second - perpendicular to this direction, and the third - always directed towards the window. Each stage is better to start a clean roller, then the divorces will not appear. Surplus paints are removed with a dry roller.

After each application stage, give paint to dry completely, it will take about 8 hours. Check the uniformity of paint, to do this, periodically move aside and look at the ceiling at a different angle. In the process, immediately can be eliminated by non-prisoners. Using a roller with a telescopic handle, you do not have to constantly climb on the staircase.

After graduating from painting the ceiling, do not allow direct sunlight and the formation of drafts. In no case do not use electrical devices for quick drying. The adoption of these tips may result in rapid paint pepper. And you will have to do all the work again