Iron - a thing in the farm needed and irreplaceable. But, like any device that is often used, it comes in disrepair. What to do in this case? Carry to workshop or buy new? Do not hurry to do anything or the other. The ironing device is quite simple, and a person who has even small skills and knowledge can cope with this task. The causes of iron malfunctions are usually associated with electricity and very rarely with a sweeping system. Guide our advice, and you can quickly learn to repair the iron.
1
For starters, stock tools. Prepare the tester and screwdriver - simple and cruciform. There will also be required passats, a knife - and you can start repairs. We will consider malfunctions, moving from simple to more complex.
2
If the iron does not heat and the control light burns, then open the back cover and see if the feed cord is working. To do this, turn on the plug into the socket and the tester check if the current comes to the terminal block. If it does not reach, the wire in the cord is probably biting. Usually it is clouded or at the entrance inside the iron, or near the plug. If near the plug, do it and put it new collapsible, and if near the iron itself, you simply remove the centimeters ten and connect again to the terminal block. If you do not want to bother, then change the cord to the new one. By the way, it must necessarily be in a thread braid.
3
If the cord is working, and the iron does not work, you need to remove the handle and the tank for water to access the iron sole. There were no problems with old Soviet iron, and on modern, all screw fasteners are hidden by plugs to give better product design. Lay and remove them with a knife tip, and under them there will be screws. In some places, plastic locks are used to open them - carefully remove the edge edge, shake a small screwdriver, and slightly pressed, open the locks. There will also be screws. Unscrew them, and the handle with a tank will be removed without difficulty. When you remove the tank, follow the rubber seals not lost.
4
When you have access to the sole of the iron, then you need to check the thermal stitch first, and then the thermostat. The first serves to not happen to fire. When for some reason, the temperature in the iron begins to increase unauthorized, the fuse burns out. Check it with a tester, and if the fuse is faulty, it must be replaced. It changes simply, it is only worth unscrew the screw that fixes it on the body, and the two screws that it connects to the chain.
5
The thermostat is used to maintain the operating temperature of the iron in a specified mode. It has a contact that is constantly closed and opens. From long work on it can be formed by Nagar, and enough contact can be carefully cleaned with small abrasive paper so that it began to work normally. But it happens, he burns completely, in this case it is necessary to change the thermostat. To remove it, unscrew the two wires connected to it, and the screw to which it is attached to the housing. Build an iron in reverse order.
6
If you have a control light on the iron, and it does not heat, then you probably burned the TEN. And since the TEN with a sole of the iron represents one whole, and the sole is actually an iron, it is impossible to repair it. You need to buy a new device. You can, of course, try to choose the sole, but it will be difficult to find exactly the same, and it will cost it a little less than a new iron.
7
If the iron began to disappear poorly, it was hammered by the salts of the hole through which steam passes. Disassemble the iron, remove the rubber seals and make cleaning. You can use different solvents.
As you can see from the description, everything is quite simple. Repair will take an hour from strength, and do not need to dangle into the workshop, at the same time and money will save money.
0
3947
