How to Clean Water Heater from

How to Clean Water Heater from

Water heater in its composition has tENwho gradually fines scolding. Therefore, preventive work should be carried out regularly. Timely service of the working system will extend the service life of the device. From the presented material you find outHow to clean the boiler and prevent premature wear of the system.

1
Despite the fact that design features manufacturers differ, the principle of work is identical. First you need to disconnect the power supply. Turn off the machine, after pulling the cord from the outlet, and you can start draining the liquid. If you have a gas heater, then break the gas supply and do not forget to suspend the flow of cold water. Disconnect the hot water hose is not necessary. Disconnect the drain hose and direct it in the pelvis, bathroom, sink or bucket.

2
Jump the hose on the boiler or water heater fuse, open the crane and thus Activate air suction. When airspace start Expanding, the water will be drained from the hose lowered in the pelvis. Now you can remove the hot water hose and proceed to clean the system. Remove the heater from the wall. Arms screwdriver And disassemble the system of the system.

3
Remove the front panel and dry the walls of the device. Reach thermostat and heating element, and after and tank. Owel gloves, inapport the whole scale and rinse the inside of the tank with running water. If there are adhered clogged particles on the walls of the tank, you do not need to shake them or calm down. You can damage the anti-corrosion layer. For cleaning, add special salts that split deposits and remove painless together with water. If necessary, repeat the procedure several times.

4
Similarly, assemble the water heater or boiler, check for technical service and tightness, then connect to the network and fill with water, test for good condition. Clean the cleaning regularly, and the service life of the heating system will increase.

5
If For 3. 4 years will not be carried out preventive work, tEN Quickly fails, filters will be clogged without the possibility of rehabilitation, the productivity of the system will decrease by 15 25%, and after and will stop working at all.

Cleaning frequency depends on stiffness Water and operating frequency. Conduct similar prophylaxis every six months, and in the intervals, run through the splitting system funds Powered by water heaters.

Add a comment

Your e-mail will not be published. Mandatory fields are marked *

close