How to lax sneakers beautiful

In this article, I would like to answer the question, how to lack sneakers to make it beautiful, and original, because sneakers are very popular youth shoes.

1
Load sneakers lacing "Forest"

It is used to shorten the long cords of sneakers and for high boots, it looks rather original.

The lace is attracted to the extreme lower loops and is displayed by the ends on the front side.
On the front side of the ends of the lace is introduced into the parallel top loops so that as a result, the ends of the lace looked inside the sneakers.
The ends of the lace need to cross and pry under the vertical lace of the opposite end of the lace and so need to rise to the end of the loops.
At the end of the cord, the ends are bred in different directions and you can make a tight node so that the laces are not untied at an inappropriate moment.

2
Lacerate sneakers lacing " Hidden knot "

Such a type of lace tying will give sneakers a neat look, but it can only be used if your shoes have an even number of hinges.

It is necessary to cord the sneakers on the technique of direct lacing, but so that the left lace in the end turned out a little shorter right.
It is not necessary to launch to the left before the edge, leaving one pair of loops, and you need to turn the right end to the end.
The node is tied inside the boot, since the ends of the lace go inside and it is desirable that it is not the inner side of the foot, since the node can crush.

3
Load sneakers with zip-zipper lacing

Very beautiful lacing, used for those who have the likelihood of losing sneakers "on the go."

The lacing begins with the bottom holes, stretched, and both end should look out.
Ends need to be wrapped behind the stitch at the same level and from the inside are sent to the upper pair of holes.
Ends crossed, you need to pry them under stitches of the same level and climb the next level.
The same movements to climb to the last pair of holes.

4
Lacerate sneakers lacing " Chess board"

This type is used for shoes, which is worn freely, without tieting the laces. It looks very original and stylish, especially if the laces will be different colors, wide and flat.

Sneakers are corded with a simple light lace lace.
The second cord is needed for a wave-like lacing from below to the top.
Wrap the second lace in the first and the same actions you need to continue to Niza.
After the second lace is over, you will need to make a node inside the lacing, the most it will not be visible.

5
Lacerate sneakers lacing " Lattice"

It looks rather original if the sneakers have an even number of pairs of loops.

Stretching the lace traditionally in the lower pair of loops, and the ends are output.
The next pair of loops is passed, the opposite ends begin to the fourth below a pair of loops.
In parallel, the ends of the lace on the inner side are descended and raised in the third pair of loops.
Thus get to the last pair of loops.