Tie - elegant accessory, successfully complementing the image of both an adult man and a young young man. The stylish attribute will emphasize the taste of its owner, becoming a concise end of the image.
But how to tie this, it would seem, not good "tape"? There are many techniques that allow you to beautifully fix the tie on the neck. Some of them are simpler, and some require a certain skill.
Tie a tie correctly
Getting started to tying a tie, some simple rules should be remembered.
- Regardless of the selected technology, observe the smoothness and softness of movements during the assembly of the node, do not stretch the tape.
- The node must be quite tight, without folds.
- It should be tied up on the collar, but not on the neck. Thus, at the output, you will receive the desired length.
- When choosing a node, pay attention to the collar of the shirt - the accessory should not look overly cumbersome.
- And remember, no matter how flawlessly tied the tie, if he does not harmonize with your rest of clothes and appearance, the whole effect will be reduced.
Testing techniques Tie nodes
Easy knot
Based on the title of the node, the technique of its formation is valid simple. Throwing the tie on the neck, position it in such a way that the wide end is below the narrow to 30 cm. Cross them. Describe a wide end around a narrow loop (wrap it to 360 °). Next, send it under the loop that on the neck and lower vertically down. At the last stage, the end should not be lowered, but to skip through the front of the node.
Node "Windsor"
Place the ribbon on the neck, lowering a wide end slightly below the narrow (30 cm). Cross it over the narrow end and grind into the resulting loop. Lower the wide part of the tape down, then on the right side, swipe it for a narrow half. Next, again, you make a wide end of the loop and send it from the left side over a narrow part. Will the ribbon in the loop (bottom) and lower it ahead of the tie down, pre-sold through the front of the node.
The bow tie
Take the butterfly on the neck, keeping the asymmetry of the ends (right below the left). Long end cross over short, grind in loop and lower down. Go to the second half. Fold it in half, imitating half of the bow (end a). Similarly, (accordion) fold the direct part of the ribbon (end b). Get the folded end b in the resulting loop. The resulting butterfly stretch in opposite sides by the edges.
Pratt node
Position the ribbon on the neck and cross it half, placing a wide part (a) on top of a narrow (b). Skip half a in the neck loop, starting it downstairs. Out it on the front side of the tie and direct down and under half B. Stretch a part A in the cervical loop and circle it a narrow half on the right left on the front side. Retire it again through the loop and pass forward through the front knot.
Transverse knot
The thin end is denoted as a, and more wide - as B. Cross the ends, placing A on top B. Next, start the bottom in the loop, output it from top to bottom, leaving a slightly free loop. Drove the end a behind the end b and send again into the cervical loop, but on the other hand. Create a through the loop left and fix the node.
If the tie is thin
This type of tie is in demand in everyday wardrobe. Place the tie on the neck, keeping the principle of asymmetry. Wide end Expand the seam and place it under narrow. Lift it up, direct in the cervical loop and return to the previous position (seam is from above). Next, unfold a wide part of the front side and spend over a narrow end. Once this half of the ribbon in the loop and output, skipping through the front part of the node.
When tying a tie, it should be remembered that its long end was located on the same level with the belt. Correctly picking up and tie to the neck, you will receive a spectacular accessory that is guaranteed to appreciate others.
0
578
