How to set the temperature on car alarm

Remote engine launch by car alarm is a popular option that can be especially useful in winter. Adjust the temperature autorun, and during the frost period, the engine warming will be carried out without your direct participation. If the temperature in which the motor will occur, it is not set, it can be done independently. How to install or change the temperature, is shown on the example of STARLINE A91 alarm.

Activate programming mode and select the desired temperature value. For diesel and gasoline engines, the indicator will be different: in the first case, the optimal temperature of -10 Celsius, in the second - -18. If the new and battery gasoline engine is charged, it is possible to install -20 degrees, but there is a risk that at such a temperature the motor will not start.

For a machine with a manual transmission, a special "software neutral" procedure is provided. The car must be put on the hand-made brake. After pressing the button with the lock icon, hold it for 3 seconds. Next, not drowning the engine, remove the ignition key and leave the car by closing the door. Re-press the button with the lock icon, the engine will stop working after 3 seconds. Car under guard.

Next Action - Checking the performance of the temperature sensor. After twofold fast pressing the button with an asterisk, the temperature should appear - it means that the sensor is normal. If the engine has not yet cooled after the trip, the display will display the positive temperature. You need to pay attention if Lo appears on the display, this means that the sensor is not installed or the temperature fell below -40 degrees.

Turning on the autorun function is made with an asterisk button. It should be pressed until the key chain erupts the first and then the second beep. Simultaneously with it, the icon will flash in the lower left corner of the display.

By pressing the button with an asterisk, move to the thermometer icon, then click the "Enable" button (with the lock icon) and wait for the audio signal. Temperature readings should appear on the display instead of hours. The autorun program is installed.

In case you have an alarm of a different model on your auto, follow the attached instructions. Remember that improvisation in this case can only harm.