To disable all the alarm security functions, the VALET mode is used - service mode. This mode is turned on by pressing the VALET switch button. It is used when you leave the car in the service station or at the maintenance station. The ability to manage some service functions is saved: Turn on the "panic" mode, spike the doors of the car remotely.
1
In the instructions for the installed security alarm, the process is turned on / off the service mode. Open this section and read it. If the required partition is not or the instruction is lost, you can try several standard actions. Each signal system is individual, however, some modes are similar, to disable VALET without the instruction just will take longer.
2
Sitting in the car, turn on the ignition for a few seconds, then turn off. In order for the process to complete successfully, it is necessary to fulfill it quickly, otherwise it is re-repeated.
3
Find the VALET key button in your car. You must from the instructions to know its location. Most often it is located on the receiver of the signal, under the steering wheel or closer to the gas pedal. Press the VALET button for two seconds once, release, after turning off the ignition, should pass no more than 10-15 seconds. Perform actions when the security is turned off.
4
The security alarm system will give two or shorter signals, LED (light-emitting diode) of car alarm twice will turn on and go out, and the overall lights flashed several times. Service mode is disabled, the auto alarm is operating in normal mode.
5
Check the control panel before turning off the VALET mode, make sure that the desired buttons are available. If you failed to find the pushbutton switch, it means that your security button has a different designation. For advice, contact the service center in which you installed alarm.
6
You can disable remote valet mode by remote control. Turn on and turn off the ignition, sitting in the car. Simultaneously press the two buttons on the remote control: the button, which shows the speaker button and open padlock. After 3 seconds the release button. Speaker will emit several signals will flash the parking lights, LED car alarm goes off.
7
If the alarm system does not respond to deactivate valet with the remote, try to take out the batteries and put them in some time - about 2 minutes. Check whether there is a connection between the remote control and the main unit. At the time of power-on screen should appear on all possible signs.
When the power is turned off valet service mode is saved, it is possible to use at car maintenance. At the time of entering the service mode in the anti-theft system, LED indicator lights steadily. Siren delivers a warning signal when the ignition is turned off. Push-button valet mode is used even to disable the armed mode, the immobilizer if the remote is lost or out of order.
0
1445
