Often situations occur when the phone falls in the puddle, in a toilet or bath. In this case, the service service may refuse to repair and restore the device will have for its own funds. Water and phone are incompatible things, but you can try to save it all the same.
First aid
If the device got into the water, then the first thing you need:
- Get it from there, because it is a rather aggressive medium for electronics. From the speed of the reaction of the device owner depends on the degree of water penetration inside. Otherwise, electronics can close and fail. In this case, the phone will have to throw out, because the repair will cost more than the new device. According to theory, it will not be able to get into the phone in a few seconds, but for 20 seconds the water will get to all nodes.
- Turn off the phone. To do this, quickly remove the lid, remove the battery, SIM card and memory card. If the battery is removable, for example, the iPhone, then perform forced shutdown. Remove the details that dismantle. Then wipe all the contacts with a dry rag. You can turn on the phone only after the end of all procedures. Due to this, you can prevent short circuit and corrosion of fees, the other chips from the salts remaining on the details. Often manufacturers are placed on the battery or near it a white piece of paper. If it became pink (the color changes due to the influence of moisture), then this means that the device is wet completely. This is not a very good signal, but not catastrophic.
- Remove everything from the phone. This is a cover, cover, plugs for ventilation of the inside of the device. Next, wipe all the dry cloth. At the same time, the phone can not be very tough, in order not to deepen even more.
Advice. It is better not to check the performance of the device after its salvation. In no case cannot immediately insert the battery and try to call someone. Such actions may finally destroy the phone.
Treatment of vacuum cleaner
Get a vacuum cleaner and a tip nozzle. For 30 minutes, process the surface of the device and all the slots. For this purpose, you can use a hairdryer, but they need to dry extremely carefully and preferably cold air. If the hair dryer works with hot air, then you need to process at a certain distance. In no case do not bring the device close, because it can only harm the device.
Omit in alcohol
This People's Council often turns out to be useful. Alcohol has an excellent properties of moisture absorption, without harming chips and connections. To do this, make a device in alcohol, pre-disconnecting the battery.
Place in Fig
Pour rice in the package (choose a large break, in order to exclude rice getting into the device) and put the device there. This product has the ability to absorb moisture and pull it out of different places. Leave in package for 24 hours. An additional drying may also be required. To do this, leave the device alone for two days and put it on the absorbent towel.
Collect and enable
After at least a day, but better a couple of days, you can turn on the phone. After all, moisture inside remains for a long time. If the phone does not work, then it will have to be included in the service center. Wizards will replace damaged parts and battery. It will cost money, but you will not lose numbers and important photos in the device.
If you observe simple instructions, you can give a new life to your phone. We wish to be neat and think about good. Make a maximum effort to save a friend.
0
445
