Low pressure tire do it yourself

Every year, the demand for cars with increased permeability is becoming higher and higher. Car lubers want his steel horse to drive everywhere. But to cope with serious off-road car requires special devices that increase the permeability. Such a device is considered low pressure tires, the cost of which is higher several times.

So how to increase the passability of your car and at the same time save? The answer is simple. Make low pressure tires with their own hands.

1

General Information on Low Pressure Tires

These tires are not at all like those that can be seen on ordinary cars. They are distinguished by their huge size. The most important difference is determined by their name - tire pressure is much less, only 2-4.25 kg / cm². Due to this feature, high permeability is achieved. The principle of operation of low pressure tires is comparable to an air cushion, they redistribute the weight of the car throughout the plane, and as a result reduces the pressure on the ground. Thus, the car with such tires is able to easily ride the swamp, snow and dirt.

2

Low Pressure Tire Production Features

For the manufacture of low pressure tire, the easiest way to use new or rubber used from GAZ-66 or ZIL car 131. You can also use old aviation tires, they can withstand heavy loads than automotive.

The beginners in this business should be stocking several spare tires. One of them can be cut and familiarized with its internal structure, as layers, which thickness, etc. are pasted. With the second tire can already be trained in the manufacture and work out several techniques:

• Cutting pieces of rubber on a template by a stationery knife.
• Ability to cut at depth.
• Wire pulling.

The development of these techniques will facilitate and speed up the work on the manufacture of tires.

3

Low Pressure Tire Making Algorithm

The process of manufacturing low pressure tires with your own hands is to gradually remove several layers from the source tire. Actions are performed according to a specific algorithm, which involves removing rubber with side parts and from the tread, removing fixing cores. Stiffness to new tires will give a new tread pattern.

So that there are no problems in the process of work, you should stock all the necessary tools: a sharp knife, timed, hammer, plumbing and winch.

Manufacturing occurs in stages:

1. The first thing the wheels must be washed and let them dry.
2. Next, draw on the wheel drawing of a new tread. You can do this by an ordinary marker, the main thing is that the marked lines are clearly visible. As a tread pattern, most often make a Christmas tree.
3. Then, on the edge of the inner circle, we make an incision. After that, we celebrate the side and cut out small pieces of rubber, the wire will be under them. It is fashionable and removed by the winch.
4. Now you can proceed to cuttings by drawn tread lines. In the place of the remap rubber, we cling to the ticks and pull it out with her winch. It is necessary to pull in such a way to tear off the unnecessary pieces of the rubber layer from the wheel. The detached parts are subsequently cut off with a knife.
   
5. We repeat the delay with other parts.
6. After taking off unnecessary pieces, we clean the bare surface with sandpaper.
7. Tire is ready, but the framework is necessary for it. It is collected from metal pipes, disk and plates. All elements are welded, welding places are grouped.
   
8. We put on the tire on the made frame and pumped up.
9. We repeat all items with other tires and put on the car.

On this, the manufacture of low pressure tires ends. Driving transport on sht is much more complicated, so observe caution on turns.