How to make a fence from the challenge

Rabita is the perfect construction material for the fence of country houses and household plots. The main advantages of hedge of a wicker metal grid are simplicity of construction, a neat appearance, a relatively low cost of components used and excellent performance.

There are several types of chain grid. The non-scattered grid of ferrous metal is considered a budget, but short-lived material. It is easily rusting, so it is most often used for temporary designs. In contrast to the previous, the galvanized chain is distinguished by the excellent corrosive stability and excellent strength characteristics. Also enjoys well-deserved consumer and plasticized grid - due to the polymer coating, it is resistant to environmental impacts, while the fence from such a material looks aesthetically and attractive.

Grid2.

To install a tensioning fence, except for the rolled mesh, you will need fasteners, wire / fittings and support poles. With installation work, it is more expedient to apply not wooden, and metal frame poles - they are much longer and more reliable. By the way, in order to reduce the maintenance of the construction of the fence, you can use the failed, but not affected by corrosion pipes.

The arrangement of the tensioning fence begins with the markup of the territory. In the corners of the site, set the temporary stakes / rhe and tension a durable cord between them. Having measured its length, you will receive a mesh metro station that needs to be purchased for installation (when you buy it to the planned length, it is worth throwing 1-1.5 m for possible errors in the calculations). Then mark the locations for the holes under the frame poles. Practice shows that the optimal distance between the supports is from 2 to 2.5 m, since the chain is a fairly lightweight and bending material.

Grid3.

In the marked places, dug the holes in order of 0.8-1.3 m. First of all, the angular pillars are always installed (they account for the greatest load), for them - intermediate. Constantly monitor the verticality of the layout of the supports with the help of a construction plumb - otherwise the fence over time "will behave."

Mount the posts as follows - put on the bottom of the deepening crushed the crushed stone and thoroughly sneak up on top of it sand and supely compact again. In the prepared "Lodge", install the pipe (the underground part of each support is pre-treated with anti-corrosion mastic) and pour with cement mortar (of two parts of cement, two parts of rubble, one part of sand and water). Then the bayonet shovel construct concrete fill. Close up of pipes with plugs.

After hardening the concrete (it takes about 7-8 days), proceed to weld the crochetors on the poles. Durable material - thick wire, screws or nails are used as hooks. When welding work, remember the safety technique - be sure to wear safety glasses, mask and overalls.

Next, proceed to tensioning the grid. At this stage you will need the help of one or two submissions. Reconnected roll Set near any of the corner posts and snap the grid on the hooks. For better consolidation in the first vertical range of chain cells, the stretch is the reinforcement rod and weld it to the support. Next, we first stretch the mesh evenly (one must hold it from above, the other - from the bottom), pass the challenge on the crochets of the following columns. In order for the grid with time, it is not deformed, through its upper and lower edge, stretch the reinforcement rods horizontally (they also need to be welded to the columns).

After installing the fence, bend all hooks. Top "Warms" Rabits Carefully wrap down (it is possible to turn a thin cable into the first horizontal range of cells and spinning the protruding "mustache"). To prevent metal rusting, open the reference pillars of paint.