A wig is a great way to change appearance beyond recognition. If you want to have a wig for everyday use, it is best to make it from natural hair and to order. If you believe in your own strength and have a tendency to needlework, you can try to make a wig yourself.
1
The first stage in the manufacture of a wig is the removal of the measure from the head and the creation of the Montuer (the cloth base). It is necessary to replace at least 8 anatomical measurements of the head for the most accurate pattern of the Montour. Usually, cotton tulle or synthetic grid is used for its production. To preserve the montour shape along the edges, and also along and across the ribbon or braid.
2
There are two main ways to fasten hair based on. This is a crashing and timing. In the first case, the finished tres is sewn to Montour. In the second - the hair is attached to the basis of a special packaging crochet. It is worth noting that the played wig requires a very painstaking work of a professional, therefore such products are usually an order of magnitude more expensive. Next, consider the technology of manufacturing a cracked wig.
3
Tres is a number of thin strands of hair that weave in a special way. It is worth remembering that the smaller the hair in strands, the better the finished product will be. There are three types of Tresa: manual Tress in one turn on 3 threads (thin), Tres 2 turns on 3 threads and machine Tres (strands are sewn on the sewing machine). Fix the strands of the hair should be on the categorous threads, they are durable and resistant to chemicals.
4
Prepare the card and the water container. Install Tresbank on the desktop. On the rods, fasten the thread - to inhale them into the hole on the rack and strengthen on the hook. Next, tie the nodule that will be the starting point for the manufacture of Tresa. To do this, remove the upper silt along with the thread and tie 2 knots.
5
We take strand of hair and comb her on a card. We do it like this: we take a bundle in the middle and comb at first one end, then another. Put the hair and combing the center. Please note that the hair is not confused - they must lie in one direction, otherwise they will constantly get into the finished product. Thus, after combing, only the hair of a certain length will remain in your hands - short will stay on the card.
6
Find your fingers into the water, also slightly moisturize the prepared and combed strand of the hair. So the weaving will be densely, the hair will not crumble while working. The first strand stretch under the bottom thread of Tresbank, above the middle and top. We do it as close as possible to the nodule. Cress your fingers the tip of the hair beam over the upper thread. Hair bases must be approximately 3-5 centimeters.
7
With the right hand, stretch the end of the hair beam under the top thread over the middle and lower. We stretch strand. Next, stretch your hair under the bottom and medium threads over the top. And last time stretch the beam under the top and bottom threads over the middle. Both ends of strands move more tightly to the node and stretch the maximum. The same actions repeat with the next strand of the hair.
8
Having finished the closure procedure, remove the slices with the right rack and fix our weaving. To do this, tie the threads for 2 nodes.
9
We cherish ready-made Tres on Montour. It is best to do on a special head-form. The end of the Tresa applies to the center of our base and sew 2-3 stitches. Next, we lake the trin tightly screwed clockwise and secure to Montuur with frequent stitches.
The finished wig is hanging with scissors, make fibilos if necessary and laying.
Share advice:"How to make a wig with your own hands"
1
2781
