The stove is a reliable friend and comrade of the hostess. How many delicious dishes have been prepared on it! During cooking, it is not always possible to keep track of the process and do without pollution. Of course, it is easier to remove the spots while they are fresh, but what if it is, due to the lack of desire or time, old spots have firmly dried up to our nurse?
1
We remove the burners and gratings from the stove, soak them in a pelvis or bathroom in a solution of baking soda, then washing them will be much easier.
2
Remove the turning handles. On some models of plates, you will have to use a knife to pick them up, and on others they are completely non -removable. Using a detergent and a toothbrush, thoroughly rinse all the corners, wash off with clean water and spread the handles on the towel to properly dried.
3
We proceed to the working area of \u200b\u200bthe stove: we like this horizontal surface more often than others, so we apply the detergent to the sponge moistened in the water, sprinkle there a little soda and with light rotating movements we clean the spots without much difficulty. Rinse the entire foam thoroughly.
3
My oven. To do this, you will need: rubber gloves, citric acid, vinegar, food soda or ammonia, detergent, refractory bowl. We warm up the oven a little, degrees up to 50, putting a bowl of water in it and 1 tsp. diluted citric acid. We dilute vinegar with water 1: 1 and apply the solution with a sponge on the walls of the oven. If the pollution is serious, we leave for a couple of hours. After sprinkle food soda on the sponge and rub dirty places. The reaction of soda and vinegar will allow you to wash even old dirt. Instead of soda, you can use ammonia. Then we wash the oven with a detergent - and it sparkles! This method is absolutely safe for health!
4
Wash the side panels of the slabs. We rarely touch these zones, because next to the stove there is usually a cutting table or sink, and it is sometimes difficult to crawl with your hand, but you often do not want to put forward. So it turns out that drops of fat are accumulated there for months and dry tightly to the surface. In gloves, we distribute vinegar with a sponge over a dirty surface and leave to soak for 30 minutes. Damage and soda are treated with pollution areas. If it is not possible to get rid of fatty drops, in extreme cases, we will use a scraper for glass ceramic or blade.
5
We proceed to the soaked lattice. If there is a special grill brush at hand - excellent, no - then we will use a hard brush, preferably with a metal bristle or a knife. After all the dirt is scrapped, we wash the grate with soda, rinse and wipe dry.
6
It is enough to rinse the burning fires after soaking with a detergent and rinse. But if there are old spots, we will use vinegar. Pour 1 cup of boiling water into the bowl and add 2 tbsp. vinegar (9%), lower it for 25-30 minutes into the resulting tool of the burner. After that, weap it, rinse and dry them with a towel.
A pure well -groomed slab, like a business card of a neat and experienced hostess, will certainly become the subject of pride in your kitchen.
1
4404
Thanks for the advice!