If you are going to tie a hat with a crochet, but do not know where to start? Take advantage of a detailed description, tips and recommendations that are set out in the article. Follow the threads, a drip of patience and proceed to work.
1
Before proceeding, prepare all the necessary material. You will need:
cap Scheme;
yarn;
hook;
scissors.
2
Take the yarn. Type of yarn Select depending on the season for which you are cooking a headdress. For winter hats, you should give preference to Angore or mohamer with a short or long pile. For an early autumn or spring, viscose is suitable or acrylic, and for summer - cotton. With the ratio of artificial and natural fibers in the yarn 50/50% will be able to avoid the deformation of the caps during the wearing and the appearance of rollers in the future. Color can be any, but keep in mind that loops are better visible on bright yarn, it is easier to consider them and distinguish. One meka (100 grams) any yarn will be enough.
3
Choose a hook for work. Its thickness must correspond to the thickness of the chosen thread.
4
Now determine the size of the future headdress. Remove the two measurements.
The head of the head or the maximum circle is measured in front through the abnormal arcs, and the back of the nape of the most outstanding part.
Height of the caps (depth) - from the top of the ear to the ug of ear.
For an ordinary cap, you will need another measurement - the radius of the flat circle, which will be the beginning of the header. Girths are divided into the number Pi (3.14).
5
It is convenient to knit on ready-made schemes, in which each sign means a certain loop and indicates their number in a row. By the following scheme will be simple and neat hat. Headdresses made by crochet, always start knit from the top, that is, from the top and down in a circle. The number of rows depends on the thread thickness. The thicker thread, that, accordingly, they will need less, therefore it is necessary to periodically do measurements.
6
Tie a chain of 6 loops and connect it with a ring (column with halfnakid). Make 3 air loops and then in a circle of 11 more columns with Caid (in each loop of the chain of 2 columns), as a result, it turns out 12 columns of the 1st row. Divide them conditionally on 12 wedges. Check out 3 air loops and take another 12 additional columns with Nakud, one at the end of each wedge. Thus, in the second row you should get 24 loops. Every row do not forget to start with 3 air loops. Check on paper, what a number you have already finished (or started), so as not to get confused in the scheme and not recalculate the columns once again.
7
In 3 row, add another 12 columns with Nakud, at the end of each wedge - 36 columns. And so on, while the diameter of the flat circle is not equal to the figure obtained from the calculation.
8
Further check the row without additives, behind it - a row with additives. This alternation is repeated 2-3 times. As the cap is unscrewed, it is necessary to try on, because from the handwriting of the needlewoman and the tightness density and the thickness of the thread also depends a lot.
9
Now knit the rows without add-ons, smooth web until the long cap will be equal to the necessary depth of the product. The last row (or 2, if the thread is thin), check the single columns. It will help the hat to preserve the shape and not stretch.
10
The last few rows can be kept the "Rubber" pattern. To make a rollback on the header, increase the length of the product for 5 cm. To decorate the last row can be any of the removal of strapping, for example, by choosing a pitch step.
Before completing the product, think about what you can decorate the cap. Perhaps it will be a pretty knitted flower, pompon or brooch.
0
673
