Headlight adjustment is a responsible business that can prevent accidents in time. Modern lamps of the main and additional light in the car can give too a strong signal, blinding drivers traveling towards. In order not to learn such situations, we will study in detail how to configure the headlights manually.
What you need to know before adjusting headlights with your own hands?
This procedure will easily hold a service station if necessary. In the same place, by means of a special device, you can control the loyalty of manual setting so that in the future there is an example to which it is worth navigating. Head adjustment is useful if they are fully replaced, installing a new type lamp or fog, as well as after the repair of any parts of the front suspension. It should be borne in mind that adjusting the headlights is made according to the standard scheme - by making it one more with one car, with a high probability easily repeat on any other. However, it is important to remember that certain manufacturers may have their own algorithms for configuring. Therefore, the ideal option for the work of manual adjustment is to make it on specific techniques on the machine and the lamps installed.
How to adjust the headlights - a universal way
Below we consider the procedure that will suit most of the cars and their owners. We will need:
- the usual wall is preferably more than more;
- the playground in front of the wall is large enough to place cars at a distance of seven-ten meters;
- any markup tools, such as chalks, paint, tape.
The actual adjustment process is carried out like this:
- Before the start of debugging, make sure that the machine meets the technical requirements - the tires are pumped, there is no overload of the axes or problems leading to the incline of the car overestimation, the headlight lamps are good and do not have defects. It is also recommended to fix the tank on half of its capacity.
- Separate lamps should be customized separately, combined - in the near light.
- At the beginning of the car park opposite the walls, within 5 to 10 meters to choose from.
- The first pharmacy is covering any dense material that blocks its light.
- We put mark on the wall, drawing points that meet the headlight center and the center of symmetry of the vehicle itself.
- We connect their line. We carry out the second below, laying from the first 5 - 12 cm. Even below, we carry out the third, measuring 22 cm.
- Through all the points of the centers, blacksmith vertical lines.
- Launch the Middle Light. Normally, its top outlines must be within the second line.
- For the fog headlamps, the border must pass on the third line.
- The inclined ray responsible for covered coverage is obliged to proceed from the intersection of the vertical line of the center and the second bottom.
If there are deviations, manual adjustment is carried out by screws placed on the inner surface of the headlights. One of them is responsible for the tilt (you can set horizontal lines), the second for raising \\ lowering the beam.
For discharge type lamps with distant light, headlight centers also mark vertical lines. Next, they are connected by the horizontal line and set aside the second by 5 cm. Above the first.
0
1381
