Very often, drivers face a bad illumination on the roads in the dark. This is really a serious problem, but it can be solved by replacing or improving optics. The most common option of improvement is the installation of bixenon lamps or bixenon lenses. If you have lens skills, you can install yourself.
1
First you need to remove the headlight. We approach the car, open the hood, find the mount - these are two bolts and one nut. We unscrew them, disconnect chips with wiring and pull out the headlight on yourself. Before disassembling the headlight, you must remove the cilia that is fastened with two screws. We remove the two brackets that connect the glass and the headlight housing, and unscrew the screw that performs the same function.
2
Now the most responsible moment of disassembling the headlight itself. The task is to heat the sealant, gluing glass and the case. This can be done by setting a headlight to a cardboard box slightly more than the headlight itself, and warm up the jack of glass and the case. As a result, the sealant softens and it will be possible to disconnect the glass from the housing. We do carefully, leaving the headlight mask on the spot (in the case). Delete all the extra details from the headlight: the old lamp, the spring, which presses it to the reflector, and the metal reflector. We remove the remnants of sealant with a knife.
3
Next Stage - Preparing Wiring Connection to Control Element .In this case, this is a N4 chip located in the left (along the movement) of the spotlight. We don't need the same chip from the right lamp - it is gently taking it with it, so that I did not hang out later. Further blades, soil and paint in three layers in the desired color. After everything dries, screw the mask to the lens case and begin the back assembly. We take a large silicone gasket from the kit, dress on the thread of the lenses. Next, we insert into the hole in the headlight reflector for the former lamp H4, on the other hand, on the lens thread, we wear a washer under the N4 base and tighten the nut. Now it is necessary to connect the power to the "Angel Eyes". Nutrition is enough for them from the dimensions. The same actions with the second header.
4
Now that the wires are displayed outside, we dress the mask, screw it and warm the sealant again (you can use a new one). We insert the glass back to the housing, screw the screw back from the back side, put on the place of the bracket. After both headlights are collected, it is desirable to leave them alone for 1-2 hours to froze the sealant.
The lenses you installed give the right xenon light, a clear black and white border - the counter cars are not blinded, excellent focusing of near and far lights.
0
3656
