How to clean the iron metal penetration

Even the most experienced hostess is immune to burn-on education on the soleplate. Standing aside for a moment, and the working surface is already plastered burnt tissue fibers or her appeared dark patina. How to effectively and quickly clean up the surface of the iron metal penetration, using simple tools that exist in every home?

1
How to clean the iron burn-on with a pencil

Before you start cleaning the soles of metal penetration should take into account that it is made of any material. It is also worth remembering that the mechanical abrasive cleaning can damage the surface of the household appliance, and he will not be able to slide on the fabric quality.

Versatile tool for removing metal penetration is a special pencil for cleaning irons. This is an inexpensive and very effective means, that can be baked-treating the surface of any type: metal, Teflon, ceramic.

It suffices to conduct hot pencil on the working surface. From touching the hot soleplate pencil should melt, but not crumble. And then wipe the surface with a cotton cloth and enjoy the results. Note that smell which allocates the tool, it is very sharp, so it is recommended to perform this procedure on a balcony or in a ventilated room.

2
How to clean the soleplate of the burn-folk remedies

Vinegar. One of the most accessible and safe means of purification of metal penetration. Dissolve one tablespoon of 9% vinegar in a beaker of boiling water and treat this solution is contaminated surface. The appliance must be hot. If the soles are the outlets for steam - remove them from pollution as possible, using a cotton swab dipped in vinegar.
A mixture of lemon and ammonia. Mix halves of lemon juice with a few drops of ammonia and delicately wipe a surface with the solution of iron. Do not replace lemon juice with citric acid in the pellets - you can scratch the surface.
Hydrogen peroxide. For treating burnt surfaces are used tablets gidroperita - hydrogen peroxide in concentrated form. Spread out on a sheet of paper and spend some tablets for him a hot appliance, remove dirt remnants of cotton cloth. If the contamination is slight, you can use the hydrogen peroxide in the solution. Rub sole cloth soaked in the solution.

3
How to clean the iron burn-toothpaste and baking soda

The metallic surface of the soleplate with old dirt can be cleaned mild abrasives, such as soda or toothpaste. Suitable for processing the most inexpensive pasta. Apply it on the soiled surface, rub with a sponge or a rough cloth. It is recommended to leave the toothpaste on the surface for 10 minutes, then remove the remnants of cloth. As effectively copes with stale Prigara on the metal surface soda, diluted with water. Gruel rub the sole agent and leave for 5-10 minutes, then rinse.

4
As clear from iron metal penetration through salt

Eliminate metal penetration to the metal surface as possible, using salt. It is important to use only salt fine grinding, large salt crystals can scratch the metal. For purification with metal penetration iron necessary for tissue or newspaper sheet pour a layer of hot salt and iron, with an effort to hold on the salt crystals. The whole burning-salt remains on, and the soleplate will remain clean. Such a method of cleaning metal penetration is not suitable for devices with Teflon and ceramic coating, is better for them to use more sparing cleaning means.

5
helpful hints

Not to seek the means to remove metal penetration with an iron, ironing observe when simple rules:

consider the type of fabric, which is quiet, using the temperature, which is intended for it;
ironed linen on the reverse side, where smaller pile;
after work, do not forget to wipe the soleplate soft cloth to remove invisible lint, which may eventually turn into a dark patina.