How to run in a car

How to run in a car

Surely every car owner knows that a new car must be riddled. From the manner of the car management, its further fate depends on the first kilometers. The correct running process will extend the service life of the main nodes of the car and will make their work not only economical, but also reliable.

1
The main rule during run-in (and in the future too) - careful attitude to the newly acquired car. Follow the first couple of thousand kilometers. Observe that high-speed mode that is registered in the so-called manual (operating manual) on your car. Fuel consumption in the future and the correct "trigger" of parts and nodes directly depends on the moderate move of the car in the operating period, so avoid driving, unreasonable accelerations and braking, do not start from the traffic light.

Running in replacement2.

2
During running a car, constantly monitor the oil level and periodically look under the bottom of the machine. Let in the car there will always be a container with oil about the supply for unexpected emergency situations - this will help to avoid costly repair work. Important moment: specialists do not recommend mixing different oils! And remember - good oil is not cheap.

Obtain a replacement

3
Avoid long-term engine operation on constant revs, and this applies to both low and high speed. Alternate high-speed modes, but do not allow sharp maneuvers, jerks, wheel slip, etc. According to experienced motorists, the optimal range of turnover for the engine in the runoff period is from 2000 to 4000. By the way, such a ride mode is considered the most economical.

Replacing photo

4
Do not allow the long-term operation of the engine at idle turns, the idle mode must be used only for engine warming. Also, at the time of running a new car, forget about the engine braking - it creates a huge load on its "non-survey" nodes and can provoke a reduction in engine power.

Replacing Masha

5
The clutch and gearbox "Iron horse" also require a neat relationship during the running time period, so eliminate the sharp pressing and "throwing" pedals, squeeze the clutch without jerks and jerking, and switch gear smoothly. Also, burn the brakes of a new car - brake pads are being developed in the first 500-600 km of mileage, so sharp presses on the brake pedal can lead to incorrect operation of the entire brake system.

Replacing the latter

6
Do not overload a new car with luggage and passengers. Refuse to run the car running from the use of trailer and road trip - if the wheels are lit in the sand, clay or wet snow, a new engine and transmission will have a considerable load. At the beginning of operation, choose roads with a good asphalt coating.

Okrakat5.

The competent rust of the newly acquired car is the key to the long and uninterrupted work of your "iron horse".

 

Add a comment

Your e-mail will not be published. Mandatory fields are marked *

close