How to install cooler

Almost all components of the computer are highlighted heat. Especially "heated air" video cards and processors. For high-quality cooling of all components of the PC, a cooler is needed - the body fan. If the standard factory cooling system is not enough, you should take care of the installation of additional equipment for air circulation inside the system unit.

Purchase a special corpus cooler. After that, armed with a screwdriver, proceed to work. The location for connecting the housing cooler is in the rear of the system unit. Remember that it follows from a de-energized device. Disconnect all devices from the block - mouse, keyboard, columns, etc.. Find a place to mount the cooler. This must be a plot with four holes for self-tapping screws. The cooler must accurately approach this site. Therefore, be careful when buying a cooling device.

Remove the rear cover of the system unit. Next, install the cooler inside and screw it with self-draws to the case. Pay attention to the correct installation of the cooler - it should work on blowing hot air from the system unit.

By installing the cooler in place, it should be connected to the computer. The interface for connecting power to the cooling device is located near the motherboard itself. Insert the wires of the cooler in the third PIN interface.

After that, put the cover of the system unit and connect all devices to the location. After that, you can turn on the computer. If the cooler works noisily, you can customize it to a quieter job. To do this, go to the computer's BIOS. Find the monitoring section and select PC Coolers Operates there.

Most often three modes of operation of cooling devices are available. Silent Mode is the quietest, coolers will work at minimum power and almost silently. Optimal mode includes extensive coolers. Performance mode is the maximum turnover of coolers. Noise level with maximum, but also cooling too. Select the mode you want and save the settings. After that restart the computer.