If you are after many years of torment and hard physical work, we decided to buy a motor-cultivator, then this article is for you. In it we will tell how to work properly with a fiberboard.
1
To begin with, install the necessary nozzle. The choice depends on the purpose and type of operation. Accordingly, to plow the virgin, select Plow. It is difficult to work on hard and solid soils, the cultivator can "ship" in the soil. In no case push it forward by force. So you will quickly exhale and spend a lot of strength, for this, the device has been created. Therefore, in order to hover the untouched soil, select Acute Knives. Before working, put high rubber boots, they will protect your legs from an unexpected scaping of nozzles. You can not cope with the control, and the sharp knives hit the legs.
2
When the motoblock dirt in the ground, do not pull it, it is heavy technique. Pendulum movements, shake the apparatus from the side to the side. It is necessary to do during the work of the motoblock, so he himself will come out of the pit, you will only help him slightly.
3
To handle a soft ground, select the nozzle in the form of anchor, it perfectly shifts the soil. During work, you need to move rows or zigzag. Reduce a slight distance between the levers, it should not exceed the width of the motor-block nozzle. Moving for this principle, you will not leave untouched areas and handle the entire soil.
4
Before starting the procedure, you will definitely collect stones, glass and branches from the garden. During operation, these items can be stuck in the shocks of the nozzle or to injury. Try to plow the earth in glasses. Please note when working on a plot with a large number of small stones, do not raise the speed, but on the contrary, reduce it.
5
Very carefully you need to work during the "running" of the motoblock. To do this, you cannot choose the processing mode of virgin. The first 5-10 hours of operation of the apparatus are easy to work on the soil explosion. The device must warm up and get used to the loads. Be sure to learn the instructions.
6
So that the motoblock lives for a long time, try to carry out maintenance on time. It consists in a regular replacement of oil and cleaning, as well as sharpening cutters. Many daches wish to save on the fuel, so cheap gasoline acquire or try to replace it with something incomprehensible (BTC fraction). In no case should not do this, you significantly reduce the service life of the device. Do not attempt to save on the oil. While working at high speeds and in terms of maximum load, some types of oil can form a solid precipitate, which clogs the assembly nodes. Through time, the motoblock will simply stop working, and its repair will turn into a decent amount.
During the "run-in" of your "helper", do not install additional cutters. At the initial stage, it is enough for 2 cutters on both sides. After the device gets used to the loads, you can install additional cutters and increase the speed of the machine. A little hardwood, you get used to the Motoblock, and it will become your indispensable assistant.
0
1538
